Length of the 4-Way Harness Included with the Rampage SuperBrite LED Tailgate Light # RA960135
Published 06/12/2015
Products Featured in This Question
Question:
I am writing about the brake light strip part RA960135. How long is the wiring that goes from the 4 pin connector to the light? I want to put it on my truck cap as a third brake light and would need the wiring to be at least 10ft long or so. If the wiring is too short, is there a 4 pin connector extension?
asked by: Ben W
0
Expert Reply:
The wiring harness of the Rampage SuperBrite LED Tailgate Light # RA960135 that you referenced is right at 41 inches in length.
For an extension you would want the part # HM48145 which is 11 feet long.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Rampage SuperBrite LED Tailgate Light Bar - Stop, Tail, Turn - 4-Pole Flat - 49" Long
- Vehicle Lights
- Accent Light
- Tailgate Bar
- Single Light
- LED Light
- Light Assembly
- Strip
- Red/White
- Rampage
more information >
Continue Researching
- Q&A: How to Reset Zero Point Calibration on Lippert Ground Control 3.0
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Flat Towing Components For A 2023 Jeep Grand Cherokee L Overland
- Q&A: Replacement Needed for Magic Chef 1.3 cu ft Stainless Steel Counter Microwave
- Q&A: Installing Air Lift Load Controller I Compressor System In 2019 Ram 1500
- Article: Trailer Wiring Diagrams