Gauge Wire Used for the Wesbar 4-Way part # W787268
Published 05/08/2015
Question:
What is the gauge of the individual wires in the Wesbar 4-Pole Flat Connector w/ Jacketed Cable - Trailer End - 8foot Long W787268? Thank you.
asked by: Scott B
1
Helpful Expert Reply:
The gauge of wire used on the 4-Way part # W787268 that you referenced is 16 gauge.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Wesbar 4-Pole Flat Connector w/ Jacketed Cable - Trailer End - 8' Long
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 4 Flat
- Plug and Lead
- Wesbar
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What Mounting Bracket To Use With LED Combination Tail Light TLL56RK?
- Q&A: Circuit Configuration in RV-Type 7-Way Trailer Wiring
- Q&A: Installing CE Smith Tail Light Protector # CE26051A on Trailer without Mounting Bracket
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting Surge Brakes Locking up When in Reverse
- Q&A: Parts Needed to Replace Brakes, Brake Lines and Actuator on Tandem Axle Boat Trailer
- Q&A: Can a 5.30-12 Size Tire be Replaced with a ST145/R12 Size Tire
- Q&A: Hopkins Impulse Brake Controller Showing E1/E2 Error Code
- Article: Trailer Lighting Requirements
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Measure a Trailer Axle
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)