Piano Hinge Recommendation for a Aluminum Ramp so that It can Fold
Updated 01/05/2015 | Published 01/04/2015
Question:
Im looking to convert my aluminum ramp into a bifold. Do you have aluminum hinges?
asked by: Tony
0
Expert Reply:
A piano hinge like the part # SH300 would work great for you to allow you to fold your aluminum ramp in half. This hinge is stainless steel too so it won't rust. You might put some thin rubber between the hinge and the ramp to prevent galvanic corrosion.
This hinge is 3 inches wide and 6 feet long.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
3" Wide Continuous Hinge - 6' Long - Stainless Steel
- Trailer Door Hinges
- Piano Hinge
- Non-Removable Pin
- Stainless Steel
- 72 Inch Long
- 3 Inch Wide
- Bolt-On
- Weld-On
- Polar Hardware
more information >
Continue Researching
- Q&A: Do The Marlboro Continuous Hinges Have A Load Rating
- Q&A: Recommended 6 Foot Long Continuous Door Hinge for a Trailer
- Q&A: Thickness and Will Hinge Kit SH300 Rust
- Q&A: Does the Orientation of the Backing Plate Matter on the Brophy Tie Down Part # RR5K
- Q&A: Difference Between the Karrier KE27JR and KE43JR
- Q&A: What's The Difference Between The Kenda Karrier Wheel And Tires # KE93JR, KE87JR, KE27JR, And KE43JR
- Q&A: How To Tell If Parts Are Missing From Rear Panel Extang Solid Fold Tonneau Cover That Blew Off Truck
- Article: Trailer Hitch Receiver Sizes
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: How to Wire an Electric Winch