2006 Chevrolet Suburban Off Road Lights

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

We do have a compatible grease seal for your 168255TC oil seal, however, we do not carry rubber coated seals in this size. The 168255TC oil seal was designed to work with oil bath hubs on a 3,500 lb axle. For the most part, axle manufacturers have…

From the looks of the photo you sent it does not look like you have an OEM suspension system on your boat trailer. I recommend securing the suspension rail to the trailer frame in a more secure manner like drilling and using bolts so that it does…

Basically, a free backing brake assembly like #T4423400, will have one shoe that is shorter than the other and the bracket will be a different shape. On a regular assembly, the shoes will by mirror images of each other. Also, on a free backing…

The UFP H-1377 correlates to a Dexter #84 spindle, which is for a 3,500 pound axle. This will utilize an inner bearing #L68149 and an outer bearing #L44649. As this is being used on a boat trailer, I highly suggest going with the etrailer.com…

You'd need a new panel like the Progressive Dynamics Mighty Mini part #PD4045KA which is the most similar to your Parallax 7345 except is Lithium battery compatible. There isn't a center section…

To replace your WFCO WF-8750P power center I recommend the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K. This 2-in-1 AC/DC distribution panel and converter charger keeps your power systems easily…

Thanks for submitting the picture of the lights you are looking for. Based on that it looks like you are in need of a 194 bulb like the part #A194B.

The Tekonsha OEM Vehicle Wiring Harness #22121 that you referenced includes all the wiring and parts necessary to install a fully functional 7-Way connector and trailer brake controller. The included brake controller harness is compatible with and…

The different size Equal-I-Zer systems have heads to match the bar sizes so the parts are not interchangeable. But not to worry, with some adjustment you can soften it up a little and not have to use a different system. You will need to lower the…

If the light mounting surface on your older Prowler trailer is not flat enough to allow for use of caulk for sealing the rear of the RV Tail Light #30-92-001 then you might want to use a weather strip tape like #WS1412 which is 1/4-inch thick x…