This replacement inner member slide fits into the existing outer member housing of your Dexter or Tie Down surge brake actuator. Fits actuator models LP80, LP85, and LP8500.
Replace worn or leaking copper washers on your Dexter disc brake caliper. These 7/16" crush washers provide a tight, reliable seal between the banjo fittings and calipers to help prevent brake fluid leaks in your hydraulic braking system.
Keyed alike lock set includes anti-rattle hitch lock to secure your 2" hitch-mounted bike rack to your hitch, 10' cable lock to secure your bike to the rack, and extension lock for Benton 4-bike platform rack.
Trying to pack more without cramming your vehicle? If you've already got a bumper-mounted cargo carrier, this kit turns it into a lockable, front-loading cargo cage so extra bags or muddy gear can ride outside, covered and out of sight.
Trying to pack more without cramming your camper? If you've already got a bumper-mounted cargo carrier, this kit turns it into a lockable, front-loading cargo cage so extra bags or muddy gear can ride outside, covered and out of sight.
Your trailer's wired right, but the brakes still won't fire. If your factory controller doesn't recognize your electric-over-hydraulic actuator, this adapter sends the signal it needs so the brakes activate, no rewiring required.
You packed right, now seal the deal. This fitted cover wraps your etrailer cargo carrier in weather-resistant protection, keeping your gear clean, dry, and out of sight. Bungee cords aren't a solution, they're wind chimes for your cargo.
All it takes is one worn brake to throw your trailer off. Replacing a single ABS brake assembly restores smoother stopping and steadier tracking, so you stay in control on steep grades, in crosswinds, and during sudden traffic stops.
Replace a cracked or faded switch bezel on your Power Gear leveling system with this black/silver trim piece. Snaps in easily for a quick cosmetic fix. Works on select Power Gear RV leveling system control panels.
Replace your RV's old or damaged awning roller and fabric with this heavy-duty assembly. Fits Edge and 2000 series 8' power awnings with a built-in LED strip. Installs more easily than replacing just the fabric.
A damaged harness can make your RV's leveling system unreliable. This 25' replacement restores electrical connections, helping your jacks work smoothly. Designed for Lippert Level-Up systems, it's a simple fix to get you back to camping.
Wish you had a quick way to swap out your batteries? Well, you do now. Easily slide this tray out of your RV so you can monitor, replace, or disconnect your batteries without wasting time rooting around a cluttered or cramped cargo compartment.
Restore your Solera Edge slide-out awning with this full idler side replacement kit. Designed for all Solera Edge toppers, it includes black-finished hardware and wire support components for a secure, like-new installation.
Replaces the electric steps, motor, and control unit for your Kwikee 47 Series RV step. Motor and control unit automatically extend and retract the steps when you open and close the door. Wiring pigtail hardwires to your RV's power.