New Arrivals

You outfitted your Kuat Ibex truck bed rack with panels for a secure, enclosed topper, but organization is just as important. This MOLLE panel mounts inside the door panel so you can mount gear.

• Accessories and Parts
• MOLLE Panels
• Ladder Rack
• Aluminum
• Black Powder Coat
• Kuat

These co-branded Kuat/Diode Dynamics covers feature a durable, rubberized design that fits securely over each DEK light pod, protecting them from damage while keeping you compliant with road regulations.

• Accessories and Parts
• Roof Rack
• Lights
• Lens
• Kuat

Replaces the gear shaft for your Kwikee Revolution powered RV entry steps.

• Accessories and Parts
• RV Steps
• Gears
• Kwikee

Replaces the mount for your Solera 3000 Series RV awning.

• Accessories and Parts
• RV Awnings
• Mounting Hardware
• Lippert

Replaces 1 3/8" x 1-11/32" pin needed for your Solera RV awning. Dacromet finish resists corrosion.

• Accessories and Parts
• RV Awnings
• Hardware
• Arms
• Pins
• Lippert

Replace a cracked or missing roller end cap on your powered Lippert Edge Slim awning. This black cap fits the end of the roller tube, protecting internal components and maintaining the awning's sleek, low-profile look.

• Accessories and Parts
• RV Awnings
• Rollbars
• End Caps
• Black
• Lippert

Replaces 1 hydraulic jack assembly and hydraulic face seal fittings for your Lippert Level Up RV leveling system. Constructed of black aluminum. Retracted height is 21-1/16" with a 9" diameter footpad.

• Accessories and Parts
• Camper Jacks
• Jack Assembly
• Lippert

Replace a missing side plug on your Lippert Power Tongue Jack V2. Push-in rubber cover (1-3/8" OD) seals the jack-head opening to keep out water, dirt, and road grimerestoring full protection in seconds, no tools required.

• Accessories and Parts
• Trailer Jack
• Camper Jacks
• Caps
• Lippert

A damaged harness can make your RV's leveling system unreliable. This 4-pin interface harness restores electrical connections, ensuring smooth jack operation. Designed for Lippert Level-Up systems, it's a easy fix to get you back to camping.

• Accessories and Parts
• Camper Jacks
• Trailer Jack
• Wiring Harness
• Lippert

Lost or bent your extension rods? This replacement set gets your white Solera slide-out awning working like new again so you can get back to smooth RV living.

• Accessories and Parts
• RV Awnings
• Extension Rod
• White
• Lippert

Replaces the control board for your Lippert OneControl electric Travel Trailer RV leveling system (672136).

• Accessories and Parts
• Camper Jacks
• Controllers
• Control Panel
• Lippert

This is the most convenient way to add LEDs to your RV awning: the light is pre-installed in a plastic strip and mounts to the wall. It's designed to get max brightness with minimal power, reflecting off the RV wall to fill the patio with light.

• Accessories and Parts
• RV Awnings
• Lights
• 16 Feet Long
• Strip Light
• Black
• Lippert

All it takes is one worn brake to throw your trailer off. Replacing a single ABS brake assembly restores smoother stopping and steadier tracking, so you stay in control on steep grades, in crosswinds, and during sudden traffic stops.

• Accessories and Parts
• Trailer Brakes
• Electric Drum Brakes
• LH
• 3500 lbs
• Brake Assembly
• 10 x 2-1/4 Inch Drum
• Lippert

Refresh the drive side of your Solera Edge 58" long RV slide topper with this full hardware kit. Compatible with all Solera Edge models, it includes wire support, switch kit, and rivet in a sleek black finish for lasting performance.

• Accessories and Parts
• RV Awning
• Hardware
• Lippert

Repair your Lippert leveling system with this replacement hydraulic pump. The 1.2-gal reservoir keeps fluid flowing, while the 4-bank manifold distributes pressure. Pre-wired for easy installation, so you can get back to smooth, reliable leveling.

• Accessories and Parts
• Camper Jacks
• Trailer Jack
• Hydraulic Parts
• Pumps
• Lippert

This brake assembly is engineered for trailers with 9,000 to 10,000 lbs. axles. Its self-adjusting to ensure optimal braking efficiency with minimal maintenance. The integrated parking brake lever adds convenience and safety.

• Accessories and Parts
• Trailer Brakes
• Hydraulic Drum Brakes
• LH
• 10000 lbs
• 9000 lbs
• Brake Assembly
• 12-1/4 x 3-3/8 Inch Drum
• Dexter

Restore the performance of your Fortress oil cap with this complete service kit. Includes rubber plugs, oil fill plugs, and O-ring seals to prevent leaks, maintain pressure, and keep your hub looking squeaky clean.

• Accessories and Parts
• Trailer Bearings Races Seals Caps
• Service Kit
• Dexter

Kit helps repair your harness on your Dexter ABS tow system.

• Accessories and Parts
• Trailer Brakes
• Electric Drum Brakes
• ABS System Wheel Sensor Parts
• Wiring Harness
• Repair Kit
• Dexter Axle

Replaces your wheel sensor on your Dexter ABS tow system.

• Accessories and Parts
• Trailer Brakes
• ABS System Wheel Sensor Parts
• Electric Drum Brakes
• Sensors
• Dexter Axle

This replacement inner member slide easily fits into the existing housing of your Dexter A-84 Series or Legacy UFP surge brake actuator. For use with triple-axle trailers with hydraulic disc brakes.

• Accessories and Parts
• Brake Actuator
• Disc Brakes
• Inner Member
• Dexter

Replaces (1) 3-1/2" x 5/8"-18 Dexter Axle press-in wheel stud for 8K to 12K disc brakes or idler hubs with 5/8" studs.

• Accessories and Parts
• Trailer Hubs and Drums
• Boat Trailer Wheels
• Trailer Tires and Wheels
• Wheel Studs
• 5/8 Inch Diameter
• Drive-In Stud
• Dexter

Restore the performance of your Fortress oil cap with this complete service kit. Includes rubber plugs, oil fill plugs, and O-ring seals to prevent leaks, maintain pressure, and keep your hub looking squeaky clean.

• Accessories and Parts
• Trailer Bearings Races Seals Caps
• Service Kit
• Dexter

Replace the pivot hardware in your Dexter suspension equalizer with this complete OEM kit. Includes bushings, bolts, locknuts, and instructions to restore quiet, reliable performance.

• Accessories and Parts
• Trailer Suspension Parts
• Hardware
• Dexter

Passenger's-side 10" x 2-1/4" hydraulic drum brake assembly features a free-backing design for smooth reversing. Fits 3,500-lb axles with 13" to 15" wheels and mounts with a 4-bolt flange.

• Accessories and Parts
• Trailer Brakes
• Hydraulic Drum Brakes
• RH
• 3500 lbs
• Brake Assembly
• 10 x 2-1/4 Inch Drum
• Dexter