This is the most convenient way to add LEDs to your RV awning: the light is pre-installed in a plastic strip and mounts to the wall. It's designed to get max brightness with minimal power, reflecting off the RV wall to fill the patio with light.
All it takes is one worn brake to throw your trailer off. Replacing a single ABS brake assembly restores smoother stopping and steadier tracking, so you stay in control on steep grades, in crosswinds, and during sudden traffic stops.
Refresh the drive side of your Solera Edge 58" long RV slide topper with this full hardware kit. Compatible with all Solera Edge models, it includes wire support, switch kit, and rivet in a sleek black finish for lasting performance.
Repair your Lippert leveling system with this replacement hydraulic pump. The 1.2-gal reservoir keeps fluid flowing, while the 4-bank manifold distributes pressure. Pre-wired for easy installation, so you can get back to smooth, reliable leveling.
Replaces one of the two M10 X 1.5 X 50 MM flat head cap screws for your Firestone Ride-Rite air helper spring kit. Attaches your upper bracket to the factory jounce bumper's threaded bolt hole in your vehicle's frame. Includes 1 screw.
Replace your lost or damaged thread plate with this genuine Firestone Ride-Rite part. Direct replacement for kit 2716. Keeps your Red Label rear air helper springs properly secured for heavy-duty load support.
Lost or broke your Firestone F3 remote? This replacement puts wireless control of your air springs back in your hands - adjust psi with the push of a button from inside or outside your cab.
Install your Curt electric trailer brake controller quickly and easily with this custom wiring adapter. Simply plug one end of the adapter into your brake controller and then plug the other end into the built-in port beneath your driver's seat.
This fitting replaces the 1/4" pushlock to male 1/8" NPTM fitting for your Demco Air Force One supplemental braking system. Straight design allows for streamlined routing of your air line.
Replaces the bent handle pin and clip for your Demco Recon Gooseneck to 5th wheel hitch adapter base (DM6021). Secures the coupler into the base platform.
Restore safe towing with this 2" ball coupler for your Demco DA70 actuator. Replaces worn or damaged coupler and bolts directly to the actuator housing.
Bolt this locking plate onto your Lippert Helux pin box to prevent the king pin from rotating inside your Demco Autoslide fifth-wheel trailer hitch. Hardware included.
Replaces the fuse holder for your Demco Stay-IN-Play Duo (SM99251 or SM99243) or Air Force One (9599007, 9599019, 9599020, or 9599021) supplemental braking system.
Replaces the 2-5/16" coupler for your Demco Recon Gooseneck to 5th wheel hitch adapter base (DM6021). Provides the attachment point for the gooseneck ball in your truck bed.
Lost a fender on the road or cracked it backing into a tight spot? This replacement passenger's-side fender assembly gets your Demco KarKaddy SS or KarKaddy 3 tow dolly looking sharp and road-ready again.
Square tube welds onto your trailer. Works with 4" width inner tubes (sold separately). Pairs perfectly with the eZ-Latch gooseneck coupler DM43KV (sold separately).
Replace the lost or damaged cable anchor in your Demco Stay-in-Play DUO or Air Force One system. Includes set screw to secure the cable in place and restore your systems function.
Replaces a worn or missing ramp bushing on your Demco Kar Kaddy SS tow dolly. This bushing ensures proper spacing, allowing the ramp to tilt up for storage and secure in lowered position for loading.