Camper Jacks Specs:
Features:
Improve the stability of your parked and leveled RV with these base pads. 7" Tall pads fit under smaller units as well as units with a higher clearance. Stack 2 pads to get 12-3/8" of height and a 3,500-lb load capacity.
More Information >Videos
for RV Jack Pads
Help Articles
for RV Jack Pads
Expert Answers
for RV Jack Pads
Based on the information I could find you are going to need the SnapPad EQ Compact Jack Pads #SP24FR4. I have included an image you can use to verify your feet do look the same to fit these pads.
view full answer...I went out to our warehouse and test fit some SnapPads on the feet of the Lippert High-Speed Power Stabilizer Jack #LC298707 and found that the 6" square SnapPads were a fit. If…
view full answer...SnapPads like the SnapPad XTRA Jack Pads for Lippert Leveling Systems w/ 9" Round Jack Feet - Qty 6 Item #SP54FR6 can be taken off and on as needed so you…
view full answer...You are correct that the kit part number 70161 that you mentioned from SnapPad is our #SP24FR4 so this would be the kit you'd need.
view full answer...Hey Ron, thanks for reaching out! We have two different steering stabilizers for your motorhome on a 2018 Ford F-53 chassis; the Roadmaster Reflex and the Roadmaster Exact Center. The Exact Center was supposed to be an upgrade to the Reflex but…
view full answer...The Clearsource Ultra RV Water Filter System w/ VirusGuard #CS87FR weighs 34.125 lbs.
view full answer...Great question, I did some research into the Furrion Vision S. **Furrion Vision S Wireless RV Observation Camera System w/ 3 LED Marker Light Cameras - 7" #FR98NR. You need not…
view full answer...Hey Joe, yes the Lippert stabilizer jack part #LC298707 does fit your Grand Design Transcend 245RL but it is sold individually so if you wanted a set for the front and the rear you would need to order a quantity of two.
view full answer...The SnapPad Prime Jack Pads #SP84FR4 are specifically designed to fit the Power Gear Leveling Systems w/ 10" Round Concave Jack Feet on your 2014 Fleetwood Bounder 34B. The Pads…
view full answer...The SnapPad EQ, #SN76FR will fit 10" octagon or concave round jack feet.
view full answer...Measure the diameter of the feet of your Power Gear setup and we'll be able to determine if the #SP64FR4 is a fit. This part number is for 10 inch diameter feet which is most likely…
view full answer...The replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System - Qty 1 #LC324269 needs to be torqued to 132 ft-lb and Lippert recommends using some Loctite Threadlocker 262 - High Strength - Up to…
view full answer...Filter Products (2)