# 1
Draw-Tite Ball Mount for 2" Hitches - 2-3/4" Rise, 4" Drop - 9" Long - 7.5K
I bought a hitch, stinger, ball and wiring harness for my 2004 Toyota Sienna. It was delivered fast, it was the right stuff, and it fit, just like it was supposed to. It really was as easy to install as it looked in your video. The video was immensely helpful too. The video showed me exactly what I needed to know to get my hitch installed correctly and it gave me the confidence to order online and do it myself. The only drawback is a loss of ground clearance but you warned me fair and square up front about that, so I can hardly complain. Thank you, that was a good investment.
# 2
etrailer 2-3/4" Rise or 4" Drop Ball Mount Kit - 7,500 lbs
This is exactly what was needed - we are pulling an 800 lb., single-axle lawn trailer and this setup is working very well. Installation took one afternoon and we were up and working the next day. THANK YOU!
Using this on my 2004 Toyota Sienna. Clears the bumper just fine and I like the easy functionality of changing the ball size. Sturdy construction!
# 3
Draw-Tite Drawbar for 1-1/4" Hitches - 3-1/8" Rise - 9-3/4" Long - 3,500 lbs
Came quicker than expected. All good .
Exactly as advertised. No problems. I used it on a Toyota Sienna, which has a very low hitch receiver. I'm pulling a small utility trailer.
# 4
Convert-A-Ball Ball Mount for 2" Hitches - 2-3/4" Rise, 4" Drop - 10,000 lbs
We used this on our 2012 Sienna AWD to pull the largest single axle closed top U-Haul trailer to move furniture and bikes 400 miles through the mountains of PA, WV, and VA with no trouble. I noticed less jerking from the hitch being transferred to our van than the last time I towed a trailer like this (though that was with a large sedan). Easy to install and seemed to have decent tolerances in regards to fit and finish. Definitely increased my confidence in towing with a light duty vehicle.
Love the ball mount. I have a Toyota Sienna and the rear seats recess into a well, therefore the receiver hitch much go underneath the well. This means the ball mount enters the receiver approximately 10 inches off the ground. By using the ball mount to raise the ball, this makes the ball around 22 inches off the ground, which is recommended height for my trailer. My only regret is that I did not request you attach a ball as I did not have any wrenches large enough to fasten it. Again, the mount is great. Thanks, Ron Baker
What our customers are saying:
"Excellent on-line service. My order shipped just a couple hours after I placed it and I received it the next day. Theres nothing more to ask for in service."