Summer Starts Here - Save up to 70%
# 1
Curt A16 5th Wheel Trailer Hitch w/ R16 Slider - Dual Jaw - 16,000 lbs
So far it works great. Only pulled in a short distance and backed it up into my driveway. Make sure you have help lifting this. Very Very heavy. Directions were average but got the job done. Love the extra turning radius on my short bed F250. Make sure all the parts are there. The handle to release the king pin off the hitch was not in the packaging. The box that the hitch and slide came in were all in tacked and looked good. Emailed etrailer and within a few hours they sent were processing the order for the handle. Arrived in 2 days. That's great customer service.
Looks like a received a returned hitch. All my hardware is missing. And still waiting on one box. The sliding rails. Starting off to a bad start.
# 2
Curt A16 5th Wheel Trailer Hitch - Dual Jaw - 16,000 lbs
I purchased both the Curt A16 5th Wheel Trailer Hitch - Dual Jaw - 16,000 lbs - C16120, and Reese Pull Pin Lock Plates for 5th Wheel Trailer Hitches - Qty 4 - RP58093 for my F350 SD 4X4 Crew Cab Long Bed. I'm pulling a 30' Retro 5th. Wheel and at times I pull my tandem axle UTV Trailer (Double Trailers) . I already had the rails installed in my truck, this fit right in and I used the new Pins and Lock Plates for securing to truck. I have pulled all over from South Dakota and the Northwest. The Hitch has performed Flawlessly. No bucking, nor clunking. Very quiet and smooth ride. I would recommend this set up to anyone for convenience of Hook up and Disconnect, Excellent towing, quiet, and the security of the lock pins. I use Disc locks to prevent access for bolt cutters.
I was fully expecting a hitch in excess of 100 pounds to show up in a destroyed box. This did not. They had taken the Time and effort to cover the box with an additional layer of cardboard and it must have had a million staples in it. It was almost comical, you will need a crowbar or large screwdriver to get it open. However, when I did finally get the package open I found a perfectly un scratched hitch with no missing parts. I have not pulled with the hitch yet but , it does look like it is going to perform great. I'm using this in a 2006 ram 2500 4x4 short bed pulling a 2015 forest river Salem and it allows 91 degrees of turning due to the clipped corners on the front cap of the trailer. I will be curious to see how long the rubber isolators last before needing replaced and if they are readily available. Also the curt sticker on the hitch was peeling off when I took it out of the box, would be nice to get that replaced.
# 3
Curt A20 5th Wheel Trailer Hitch - Dual Jaw - 20,000 lbs
Love it. Easy to take apart and move! The instructions were very clear on how to assemble. I pull a 43ft camper and have yet to have any problems! Well worth the $$
I have towed with the Curt A20 for a few thousand miles. I really like this hitch. The visual hooked versus unkooked indicator is awesome. It operates flawlessly. I do get some chucking over bridge expansion joints. However, it seems like most people have this problem. On normal roads it pulls great.
# 4
Curt A20 5th Wheel Trailer Hitch w/ R20 Slider - Dual Jaw - 20,000 lbs
Great Hitch, very happy with this unit. Have pulled the 18K lb fifth wheel over 25K miles (Florida to Idaho, back to Florida and now Alaska). We have covered many rough roads and challenging situations, without problems and have never had a bad couple. The hitch indicator on front of head gives a clear indication of latching condition, and the latch handle has a locking pin for added protection. This pin is the only issue I have had, which can be trapped under the slide plate if your truck is at an angle (beyond about 35 deg) from the rv. I make it a point to pull this pin prior to backing if I am the least bit concerned. This is a great hitch! Excellent quality and it's made here in America.
This is very well built and operates great. Once I got the first rail positioned and mounted, everything else was very easy. The R20 slider came in a single box and was very heavy. The packaging is not suitable for the weight. As others have also reported, the package was completely demolished when it arrived. Thankfully , all the part’s made it okay and nothing was damaged. I love the product.
# 5
Curt A16 5th Wheel Trailer Hitch w/ Slider for Ford Towing Prep Package - Dual Jaw - 16,000 lbs
Curt A16 with Slider base for Ford OEM Pucks I went through a good bit of anxiety after trading my 2013 F-250 for a 2018 F-250 due to the height of the 2018. I did not pay close enough attention to bedrail and rear height and I was beside myself sick over it so this review might be a bit long while I explain my journey. I replaced a 2013 F-250 4WD with a Reese Pro Series 16K square tube slider universal mount with a 2018 F-250 with OEM pucks. I pull a 2015 Prime Time Crusader 315RST. I measured, I had boards with levels, mock up on hitch height, I read every forum and article I could find and still I was worried I had made a big mistake. Finally, I called eTrailer and talked to Molly and she had, (or went and got) plenty of answers as I had narrowed it down to the B&W BWRVK3370 20K Companion Slider and the Curt A12. I decided to not go for the “the most expensive is better” and went with the Curt A12 saving me about $300. The 20K B&W was the smallest they had and with an F-250 I would never really come close to that weight before I passed the GCVW limit so it made no sense. The Slider base for the Curt says it is the same base used up to 24K so if I ever do I can just buy the new head I believe. Ordered on a Saturday it arrived on Thursday at noon. No issues with shipping at all, the hitch came in 2 boxes strapped to a pallet. No damage like others experienced. Assembly took me about an hour because it is heavy and awkward to line up the slider linkage but all in all nothing too difficult. I set the hitch head mount at the 2nd from the bottom (18 inch) hitch height because I had measured the truck and camper and was worried about having 6 inches of clearance camper to bed rail. Turns out on a 2018 F-250 4WD at the 18-inch level on the hitch I have 8 inches all around and 7 inches at the highest point on the tailgate. After I installed the hitch and put the camper on the truck and applied weight I got about 3-4 inches of squat, which made the already rear high truck sink to near level. I do have more nose high attitude on the trailer than I had before but it was not terrible. I moved the height adjustment down to the 17 inch (lowest) today to lessen the nose high attitude by another inch and I have 6+ inches clearance still. The hitch. Like I said before I had a Reese Pro Series 16K slider and it was noisy as hell. Kingpin clunk starting and stopping, creak at every bump and turn. I put the Curt A16 in and took the trailer for a drive with the rear slider window open and heard nothing. Absolutely nothing. No start/stop clunk, no creaking, nothing. Hook up was very easy and the interlaced kingpin jaws make visual check very easy. Operating the slide takes a bit more effort but it worked fine and locked securely. It did not latch back to maneuver and then back again to towing automatically like the video without jostling the handle a little but I am sure it will once broken in and I grease it a bit more. The puck system was easy to adjust and make a solid connection to the truck with no play. I could not be more pleased with the hitch. Cons- The hardware was packaged like one would expect and it was all there but the bolt for the center connection of the slider linkage was different than the handle and passenger side joints. It is too small and caused a lot of play. I used it anyway but it allows play in the handle and not firm for unlatching. I will replaced it today and now it works great. eTrailer is now my go to store for trailering supplies.
2017 F250 curt A16 slider Ford prep package
What our customers are saying:
"WOW! I am impressed! I called to place my order and real person answered, spoke perfect English, albeit a slight southern accent, and my order was sent within a day, shipped quickly and I had it a few days later. I saved over a hundred dollars over local and installed it my self. I cant imagine how that they could do any better. THANKS!"