Most Popular Gooseneck Hitch to Fifth Wheel Trailer for 2014 Dodge Ram Pickup

I decided to buy the Champion fifth wheel hitch to pull a fifth wheel camper, my 2004 Dodge Ram 2500 already had a B&W goose neck hitch in it. The champion hitch allowed me to also have a fifth wheel hitch with out drilling and mounting more weight to the truck. The instructions for assembly were clear and easy to follow making the assembly of the hitch easy. The hitch fit snug and there is no play in it. The 26' fifth wheel camper pulled nicely, no surging or swaying.

Click to Enlarge

Awesome product. Best of both fifth and goose put together about time. No annoying rails on my trucks bed, just remove fifth wheel flip gosse over and hides in hole within minutes. 2016 350 Ram. 38' 5R no problem nice setup.

Click to Enlarge

It is a great investment. I did not want to put the rails in my truck and this was the answer to utilize my gooseneck set up for my fifth wheel. It also provides a lot of room in the bed of my truck

It does what it's supposed to

The Demco Recon is easy to set up on my B&W turn-over ball gooseneck hitch. I went with this combination since the Demco Recon is not as heavy as the B&W Companion so I can remove the 5th wheel setup by myself. The Demco is a quality constructed product that I am looking forward to may years of service with. The only recommendation I would have is to have the torque specs for the ball capture pin and the plate yoke bolts on the unit. I just wrote the specs on the unit in silver Sharpie so I would not need to look it up every time. Installed in a 2014 Ram Mega Cab diesel 4x4 which leaves enough room for an RDS 80 gallon aux fuel tank at the front of the bed.

Put this setup on a 2021 pj flatbed with a recessed gooseneck (believe it's a b&m 30k kit) in it from the factory. The top of the ball is about 1/8"-3/16" lower than the deck. Took a few tries to make everything fit along with some modifications to the set screws. I had to trim off about 1/4" on the bottom set screw to clear my opening. Also I can't set the 5th wheel height to the lowest setting because the upright casting sticks out the bottom of the frame. One could trim that off as well but then you lose the hole for the highest setting. Gonna run in the middle setting and if I have to, I'll trim off the excess to make it sit lower. Bed is on a 2014 Ram 4500. Top of bed to ground with no load is 41.5" at the rear axle. Overall looks like it will work for what I'm doing.

I decided to buy the Champion fifth wheel hitch to pull a fifth wheel camper, my 2004 Dodge Ram 2500 already had a B&W goose neck hitch in it. The champion hitch allowed me to also have a fifth wheel hitch with out drilling and mounting more weight to the truck. The instructions for assembly were clear and easy to follow making the assembly of the hitch easy. The hitch fit snug and there is no play in it. The 26' fifth wheel camper pulled nicely, no surging or swaying.

Click to Enlarge

Awesome product. Best of both fifth and goose put together about time. No annoying rails on my trucks bed, just remove fifth wheel flip gosse over and hides in hole within minutes. 2016 350 Ram. 38' 5R no problem nice setup.

Click to Enlarge

Put this setup on a 2021 pj flatbed with a recessed gooseneck (believe it's a b&m 30k kit) in it from the factory. The top of the ball is about 1/8"-3/16" lower than the deck. Took a few tries to make everything fit along with some modifications to the set screws. I had to trim off about 1/4" on the bottom set screw to clear my opening. Also I can't set the 5th wheel height to the lowest setting because the upright casting sticks out the bottom of the frame. One could trim that off as well but then you lose the hole for the highest setting. Gonna run in the middle setting and if I have to, I'll trim off the excess to make it sit lower. Bed is on a 2014 Ram 4500. Top of bed to ground with no load is 41.5" at the rear axle. Overall looks like it will work for what I'm doing.

The Demco Recon is easy to set up on my B&W turn-over ball gooseneck hitch. I went with this combination since the Demco Recon is not as heavy as the B&W Companion so I can remove the 5th wheel setup by myself. The Demco is a quality constructed product that I am looking forward to may years of service with. The only recommendation I would have is to have the torque specs for the ball capture pin and the plate yoke bolts on the unit. I just wrote the specs on the unit in silver Sharpie so I would not need to look it up every time. Installed in a 2014 Ram Mega Cab diesel 4x4 which leaves enough room for an RDS 80 gallon aux fuel tank at the front of the bed.

This hitch mount is great! I can now swap over from my 5th wheel hitch to a gooseneck in minutes. This is a great product. I had a gooseneck hitch already installed in my pick up but needed to tow my 29 foot 5th wheel. I other mounts to install the 5the wheel to my 2013 Ram but the gooseneck hitch mount was in the way. Found this set up on line at etrailer.com . Fast shipping, Ez to get my order in. 100 % satisfied. Plug and play. Took less than 10 minutes to install.

This product worked great. Used it in a 2016 Ram 2500 4x4 with the B&W turnover ball. The only problem is the safety chains for the B&W wont let this set flat against the bed of the truck. I solved this problem by using a heavy duty 1/4 inch rubber bed mat between the bed and this bracket and cut the rubber around the B&W hole and safety chains. That helped take up the extra space and helped to protect the spray in bed liner from being rubbed. Had no problems towing my fifth wheel and was happy I don't have these rails permanently mounted in my truck bed.

Fits perfectly into curt goose neck hitch. My reese 5th wheel hitch fits on the rails perfect. I haul dirt bikes in my truck so being able to take the rails out is perfect..... nothing in the way of loading or unloading

Click to Enlarge

Fits a little loose but all in all ez install great solution to utilize all Towing capabilities

Click to Enlarge

Click to Enlarge

Click to Enlarge

Fits perfectly into curt goose neck hitch. My reese 5th wheel hitch fits on the rails perfect. I haul dirt bikes in my truck so being able to take the rails out is perfect..... nothing in the way of loading or unloading

Click to Enlarge

Fits a little loose but all in all ez install great solution to utilize all Towing capabilities

Click to Enlarge

Click to Enlarge

Click to Enlarge