# 1
Epicord 7-Way Molded Trailer Plug with Junction Box - 10' Long
The trailer plug/junction boxes worked out very well! Using them made it a lot easier to rewire the trailer.
I installed this product yesterday and it is a really nice product. It would be a great product if the darn wire colors from the plug were the same as the industry standard. But if you go by what is on the small mount that the wires screwed to it is accurate. I got the longer 10' cable as I wanted to mount it further back than the stock metal electrical box that they mount all the stuff in from the factory. I ended up mounting it on the bottom side of the cross braces on the bottom side of the trailer. I also installed a seperate fuse box to individually fuse all the circuits so that if anything on the trailer shorted out it wouldn't blow the fuses in the truck.
# 2
I mounted mine onto a piece of aluminum flat stock on the trailer “A” frame to reduce rock impact from Nevada’s gravel back roads. There really wasn’t good location on inside of trailer frame rails, was adding electric brakes and converting from 4 pin to seven. . I’m pretty darn happy with this junction box as it made rewiring rather straight forward. Our local 12 volt guru at the auto electric shop was duly impressed-wanted to know where I found it.
One of the best set-ups. This is definitely the way to go with your trailer wiring. The built in labeling inside aids in installation and troubleshooting. Make sure to provide some impact protection if mounting this in and exposed area.
What our customers are saying:
"You folks are fast. Thank you very much."