Most Popular Replaces King Pin for 2001 GMC Sierra

I love my Goose Box. I tow with a Short Bed Sierra 2500HD, and have no issues with turns. I DO have to dump my airbags or I'll have issues hitting the bed on sharp sharp turns, so it's just habit for me now to dump them when I hit a parking lot, and air them back up when I get back on the road. Something to keep in mind if you run rear air suspension without a remote. With this setup on my Forrest river Wildcat I can hit about 75/78 degrees before i get concerned with clearance. In practice I've never needed that sharp of a turn to get in a campground. After I unhook I can have ALL of my bed space back in the 15 seconds it takes to climb in the bed and stow the B&W gooseneck ball. The unit tows great, but you need to check the airbag before every trip. Easy to do with the visual bar system this is set up with. Very little chucking over nasty road joints. Overall I don't think I'd want anything else on my 5th wheel RV. The GEN-Y setup does look nice, but this one has Lippert's endorsement, and it's a really great unit.

Not As Advertised and Horrible Customer Service at Reese! The pinbox came without installation hardware or directions. The hardware took a month to replace and again came without directions. The pinbox DOES NOT have the air valve as pictured. When I called Reese I was told it was due to a parts shortage and the person I spoke to told (Paul) me the new set-up was a dumb design. I TOTALLY AGEE!! To inflate one person has to literally crawl under the pinbox while hitched to inflate while another watches the bar. Not easy for a 60+ year old fat man! The valve faces OPPOSITE the bar side. Just dumb. When etrailer followed up they were basically told I have to live with it. NO - NOT HAPPY!

Click to Enlarge

I love my Goose Box. I tow with a Short Bed Sierra 2500HD, and have no issues with turns. I DO have to dump my airbags or I'll have issues hitting the bed on sharp sharp turns, so it's just habit for me now to dump them when I hit a parking lot, and air them back up when I get back on the road. Something to keep in mind if you run rear air suspension without a remote. With this setup on my Forrest river Wildcat I can hit about 75/78 degrees before i get concerned with clearance. In practice I've never needed that sharp of a turn to get in a campground. After I unhook I can have ALL of my bed space back in the 15 seconds it takes to climb in the bed and stow the B&W gooseneck ball. The unit tows great, but you need to check the airbag before every trip. Easy to do with the visual bar system this is set up with. Very little chucking over nasty road joints. Overall I don't think I'd want anything else on my 5th wheel RV. The GEN-Y setup does look nice, but this one has Lippert's endorsement, and it's a really great unit.

THIS IS THE THIRD FIFTH WHEEL HITCH THAT I HAVE HAD SINCE 2016. IT IS HANDS DOWN THE BEST HITCH I HAVE HAD AND SEE NO OTHER REASONS TO MAKE ANY FURTHER HITCH CHANGES IN THE FUTURE. THE REASON I GAVE IT 4 STARS IS BECAUSE OF THE LIST OF IMPROVEMENTS THAT I HAVE LISTED BELOW. I HAVE HAD THE HITCH FOR 1 YEAR AND HAVE PUT APPROXIMATELY 10,000 MILES ON IT. WHAT I LIKE: -IMPROVED THE TOWING EXPERIENCE IN TERMS OF RIDE COMFORT WHEN TOWING -UPON DISCONNECTING FROM THE CAMPER, THE ONLY THING LEFT IN THE BED OF THE TRUCK IS THE GOOSE BALL. -REDUCED CHUCKING. IT ELIMINATES ABOUT 90% WHAT NEEDS TO BE IMPROVED: -THE COUPLER ON THE KING PIN NEEDS TO HAVE A FUNNEL (similar to the Anderson hitch) THIS PROVIDES A MARGIN OF ERROR WHEN RECONNECTING THE TRUCK TO CAMPER. WITH THE CURRENT COUPLER, YOU HAVE TO BE DEAD ON WHEN RECONNECTING. A CHEAP ACCESSORY TO HELP IN THE ALIGNMENT OF KING PIN TO THE GOOSE BALL ARE TELESCOPING TENNIS BALLS. -EASIER ACCESS TO PUTTING AIR IN THE AIR BLADDER. IF I KNOW THAT I NEED TO PUT AIR IN THE BLADDER, I WILL DO IT WHILE THE CAMPER IS DISCONNECTED FROM THE TRUCK. I FOUND IT EASIER TO LET AIR OUT THEN TO PUT AIR IN WHEN THE KING PIN IS CONNECTED TO THE GOOSE BALL THERE ARE SOME GOOD VIDEOS ON THE INTERNET THAT HAVE GOOD TIPS AND TRICKS THAT MAKE USING THE REESE GOOSE NECK EASIER. THIS IS ONE OF THE BETTER ONES.

This hitch reduced chucking very well, I have a 2004 3500 Dodge Ram 4x4 Conestoga riding truck with very stiff suspension, the torsion action of the hitch definitely helps when crossing bridges and pot holes. The 5th wheel is an older Keystone Copper Canyon that is in great shape. I Have 12K miles with the new hitch.

Click to Enlarge

I love this hitch I put it on my 35’ Astoria fifth wheel it pulls great and the shock absorbers help with a smooth ride.we took a ten day trip from Ga to Maine last September and had no problems with this hitch. I guess the only negative is that it’s not as easy as a regular fifth wheel hitch to hook up by yourself but after a few times you can line it up ok. The best thing is that no big hitch taking up space in my truck bed just a ball

Click to Enlarge

This product is a chucking ENHANCER, not a chucking dampener. Additionally, despite what you have read, my experience with GenY customer service has been terrible. GenY will not support their warranty program, they will try to tell you everything is OK, when the fact is, their product is faulty and does not function to GenY product literature statements “Built-In Suspension Creates Up to 90% Smoother Ride”. I purchased the GenY executive hitch from eTrailer on 3/10/23, etrailer sent the wrong unit and to etrailer’s credit - they quickly took responsibility and replaced with the correct unit on 3/24/23. I installed on my DRV Elite Suites PS3 just in time to attend the SOITC rally at the Outer Banks on 4/13/23. When we left for this 750-mile one-way trip, the GenY load indicator was in the middle of the green zone, I measured the pin load at 5,200 pounds. Bedrail clearance was my reason for buying the GenY, it replaced a Trail Air on my DRV and a Reese 27,000-pound hitch on my 2022 F450. Bottom line, the GenY system provided no improvement in bedrail clearance, but did offer the ability to switch in different gooseneck balls to adjust for bedrail clearance. GenY states that a 1,000-mile break in period is required before the GenY torsion system is fully effective. My experience was that at 750 miles the torsion system on the GenY had sagged to it lowest point with the load indicator in the unit outside of the green, this also resulted in losing nearly two inches of bedrail clearance. It looks like it has a metal-to-metal stop so that the lowest the indicator will go is to the white lines outside of the green. I called GenY from the RV park and was told that the unit would not sag further. I purchased a Curt gooseneck ball which was 2 inches higher than the Ford ball to regain bedrail clearance having to rapid ship it to the RV park. Chucking became downright scary on the 750-trip home. As an example, chucking was induced every time my truck’s ten-speed transmission shifted up. Upon arrival home, I again contacted GenY customer service with a full expectation that GenY would replace the unit. Instead, here is their response: “I spoke with our QC Manager regarding your hitch. He said that you are in the correct unit and being at the top end of the green is normal after the break-in miles. As for the bedrail clearance he said that you would be able to lower the pin box down a set of bolts (with our pin boxes you are only required a minimum of 4 grade eight bolts per side) or use a B&W ball as they are roughly 1 1/2” taller.” This is unacceptable...

Click to Enlarge

Click to Enlarge

Without a doubt the biggest difference maker I have ever used in my 50 plus years pulling trailers. When my wife had to concede that the Gen-Y gooseneck hitch made such a drastic difference.... enough said!

The Gen-Y gooseneck has been excellent! I now have approximately 12k miles on mine and it rides very nicely with very limited chucking and handles rough roads very well. I’d highly recommend that you contact Gen-Y BEFORE ordering to ensure you get the correct load rating product. Gen-Y and Etrailer have provided excellent customer and tech support! This product definitely frees up your truck bed and does require a precise line up to hitch.

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Makes life a lot easier l don’t have to remove my hitch from the bed of my truck to use it. Just flip the ball and there you go. The gooseneck hitch actually pulls better than the 5th wheel hitch I had. It is rather heavy so come up with a good plan for installing, I used the front end loader on my tractor which allowed me to do the install by myself. Great product!!!

Click to Enlarge

I love my Goose Box. I tow with a Short Bed Sierra 2500HD, and have no issues with turns. I DO have to dump my airbags or I'll have issues hitting the bed on sharp sharp turns, so it's just habit for me now to dump them when I hit a parking lot, and air them back up when I get back on the road. Something to keep in mind if you run rear air suspension without a remote. With this setup on my Forrest river Wildcat I can hit about 75/78 degrees before i get concerned with clearance. In practice I've never needed that sharp of a turn to get in a campground. After I unhook I can have ALL of my bed space back in the 15 seconds it takes to climb in the bed and stow the B&W gooseneck ball. The unit tows great, but you need to check the airbag before every trip. Easy to do with the visual bar system this is set up with. Very little chucking over nasty road joints. Overall I don't think I'd want anything else on my 5th wheel RV. The GEN-Y setup does look nice, but this one has Lippert's endorsement, and it's a really great unit.

Installation was a breeze. I have not towed with it yet, but am sure it will perform as expected.

Man,this thing is GREAT! It was 1 day late on delivery, but other than that, it bolted right up using the existing holes, NO DRILLING! I was THRILLED! It works as advertised, the powder coat paint is awesome, the auto latch works flawlessly. I am very pleased I would recommend anyone wanting to switch a 5th wheel kingpin to a gooseneck to use Gen-Y. They got their act together!

Click to Enlarge

Click to Enlarge

product delivered quickly and packaging was in tack. installation was pretty easy using a tractor. the ride was much improved over a sliding standard pin box system. this system opens up the rear bed space and and allows the ball to be removed like nothing was ever installed. I used the 4 inch offset from B&W to help turning radius on our short bed Ram also devivered from e- trailer. great customer service