Summer Starts Here - Save up to 70%
# 1
Hopkins Active Tail Light Converter with Install Kit
2000 Cadillac DeVilleEasy to install and works great.
Excellent. The only down side for my Lexus RX300 was not having an “easy” way to mount male 4-way next to hitch rather than stowing it beside tire bay. No big deal just a plus.
# 2
35 Ft 4-Way Trailer Wiring Harness - Wishbone Style - 42" Ground
Replaced the wiring and lights on my 1992 boat trailer. I was able to get everything needed from etrailer. I think Optronics is of the highest quality and recommend both etrailer and Optronics product.
Works very well after re-wiring trailer lights with waterproof distribution box.
# 3
Hopkins 7-Way RV Style Connector with Molded Cable - Trailer End - 8' Long - RV Standard
Çable good but after putting new 7way plug on truck cable wire colors did not match etrailers picture
7 pin connector separated from cable. I was expecting that "Molded Cable" meant that the connector was fused to the cable insulation but instead, the two separated almost immediately after I installed it. It still works fine as the wires are connected securely inside the connector but with the outer covering pulled out like this, I don't think it will last very long.
# 4
Tow Ready 4 Pole to 5 Pole Trailer Wiring Adapter
Simple and easy to use; just plug it in and connect it to the trailer harness. Works like a charm!
Not installed yet but looks as good as one used before in a former vehicle. The actual adapter I received is "Reese", which is a reputable brand for towing accessories.
# 5
7-Way Molded Trailer Wire Connector - 3' Long
I've had this in use for over a year and they don't build them like they use to. I use this on a gooseneck trailer and the piece of plastic behind the spade connector for the clearance lights and brakes has melted, allowing the spade connector to lose contact with the plug on the pickup. So the lights would cut off in the middle of the night and would have to wiggle the connection till I could fix it. I have an older Hopkins plug and never had this problem. To fix the problem I ended up putting pieces of thin copper wire behind the spade and have done it twice since the plastic melted a 2nd time and once again the trailer clearance lights would quit working. Attached are before and after pictures.
After a year doing its job well.
# 6
Great product no issues at all. Product as described & fit properly.
Pretty straight forward. I used it to switch my European trailer's connection to be able to connect to my Wrangler's 4-pin trailer hookup. No issues. works great.
What our customers are saying:
"Your internet site is very well organized and easy to use...My order was shipped very promptly and included everything I ordered...All in all this was a simple procedure for what can be a complicated order. I would use your company again or recommend you to others. Your selection was broad and your prices fair."