Most Popular Lets Go Aero for 1986 Nissan Pathfinder

We looked all over for a hardshell storage pod, one that would fit 300 pounds of embroidery hardware. This one from Gearspace fit the bill. Super easy checkout with etrailer.com, and they were the only ones to offer free shipping, and since this is a larger, heavier item, that means LTL Freight. Not [online vendor] and not the Mfg. The GearSpace 34 arrived earlier than promised, and it was an easy unload if you have room for a sixty foot tractor trailer. 190 lbs on a pallet, but it will load right into the back of a pickup real easy. Took about 30 minutes to install, and it went like a breeze. Light test, check... signals, check. Ready to roll on our next RV trip, with lots more room for goodies along the way. This item gets an A+, it works as advertised, and etrailer.com was GREAT. They communicate often and update on order status. even sent out an email to get customer feedback and review, along with some pictures. I'm sure after this stellar review they will send me a nice etrailer hat & Koozie Pictures show the Gearspace 34 loaded with about 200 lbs right now. It never moved an inch and is solid on the mounting hitch hardware. You will not be disappointed with this product, it's top of the line for RV rear storage.

Click to Enlarge

Click to Enlarge

Click to Enlarge

The gear space was delivered assembled; it took m15 minutes to attach mount into receiver and secure. My wife and I were able to lift onto mount with no problems. Looks great on the back of our Renegafe Vienna. An excellent solution to additional storage for full time Rv.

Perfect sized box for carry sized luggage and softball game day gear. Proven space saver. Receiver is showing signs of rust otherwise would be a ten. Would buy again.

Click to Enlarge

Click to Enlarge

Click to Enlarge

The cargo carrier generally performed as intended, but it took a lot of tinkering and a warranty replacement of the lid to complete things to our satisfaction. On delivery we found that both two aluminum side stiffeners had been bent during shipment, and were replaced fairly quickly. We then found excessive play in the fit with the receiver, and it was impossible to accommodate a "noise reduction clamp" properly at the hitch, so I used part of a bent aluminum stiffener to apply pressure across the connection between the receiver and the hitch. And lastly, the lid section was warped by over 1", which still kept rain out, but did not keep fine dust out, and it was very unsightly. After a bit of discussion, a replacement lid was provided at no cost, which I have not yet had the chance to inspect as it was delivered to our Arizona home over the summer, and we spend the summer in Canada.