2011 Ram 2500 Truck Bed Extender

As you can see in the diagram I provided, the tilt is adjustable up to about 45°. The tilt mechanism has a pin that can be used in two different positions to allow a roughly 15 or 30° degree tilt or the pin can be completely removed for the…

Hey Deb, You could just remove the load stops for the Rhino-Rack T-Load Hitch Mounted Load Assist and Support Bar #RTL002 and clamp on one kayak carrier like the Rhino-Rack Kayak Roof Rack w/ Tie-Downs #S512-S512X to the crossbar and the other to the…

For a truck bed extender with a bar wide enough to carry and haul something that is 38 inches wide you could use the Flint Hill Goods Truck Bed Extender - 2" Hitches #FHG89ZR which has a load bar that extends up to 48 inches wide.

The diameter of the crossbar on the LongArm Truck Bed Load Extender, Item #Y01149 is 2 inches. This is more designed for carrying kayaks like how I attached a picture of and not with a roof rack carrier. For what you are looking for the Rhino-Rack…

The #Y01149-1150 is the the #Y01149 paired with the Height Extension for Yakima LongArm #Y01150. The Erickson Big Bed Load Extender #EM07600 you purchased has the highest capacity at 400 lbs.

Without the extension piece installed the Yakima LongArm Bed and Roof Load Extender #Y01149-1150 sits 9" out and 46-3/4" up from the center of the hitch pin hole (see attached photo). The extension piece adds between 7-1/2" and…

The Yakima LongArm with Extender, part #Y01149-1150, can be used as a lift-assist like the Rhino-Rack T-Load, part #RTL002, in theory. However, the setup is not ideal or one I recommend. The advantages the T-Load has are the loading strap and the two…

For your Thule truck rack aero bars, the Thule DockGlide #TH896 is better if you want to slide your kayak from the back and utilizes felt pads to protect your boat and ease loading. I've attached a video to assist. The contrast is the Thule…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Yes! You can use both a kayak rack and a truck bed extender on your 2021 Jeep Gladiator with the Trail Rail system. Since the Access Lorado Soft, Roll-Up Tonneau Cover #A53VR leaves the stake pockets completely open, you will be able to install a way…

The roller part #MAL52VR is 2 inch in diameter and has a 375 lb capacity when used in the upright carrier part #MAL32VR.

At this point in time we haven't had the chance to install the Yakima LongArm Truck Bed Load Extender #Y01149 on a 2019 Ford Ranger, but we do have some dimensions on it that I think will be useful to you. If you check out the attached…