Water gets behind the shower when the pan and walls do not match the space or drain. This kit pairs a 40" x 24" shower pan with a right-hand drain and a 5-piece wall kit, giving you a sealed shower you can step into and use with confidence.
Replacement jobs can go sideways fast when the new shower base doesn't match the opening or the drain lands in the wrong spot. This kit starts with a 40" long x 24" wide shower pan with a right hand drain setup, a 2" drain hole, and the drain center 4-7/8" from the closest edge, then pairs it with wall panels sized at 40" wide x 24" deep x 67" tall. When those numbers line up with your existing space, you can swap out the old shower area, connect a standard 2" drain strainer (sold separately), and keep the project moving without tearing into surrounding walls.
Getting a full surround into a small bathroom can stall the whole replacement before the first panel is even in place. This wall kit uses a 5-piece design, giving you individual panels you can carry, position, and mount with the included screws and pressure sensitive tape. Once the panels are up and the shower area is enclosed, you're working with a complete wall setup that fits the room you have instead of leaving the job half done.
Cracked shower pans usually trace back to poor support under the floor, which turns one repair into another. This pan uses a pre-installed foam base that supports the bottom and keeps it seated securely and evenly during installation on a prepared surface. Once it's in place, the floor stays supported underfoot while you step in, turn, and rinse off.
Leaks around the base and wall seams can turn a simple shower replacement into damage behind the enclosure. The pan uses a 3-sided flange and a 4-5/16" deep basin to direct water back toward the drain, while the wall kit covers the shower area and requires silicone adhesive and latex sealant (not included) to seal all joints after installation. Once the seams are finished, water stays inside the shower footprint and the surrounding interior stays ready for the next trip.
Older shower spaces aren't always perfectly square, and that can leave gaps that are tough to hide when you're trying to wrap up the install. The ABS wall panels can be trimmed or sanded to match uneven alcoves, and the molded subway tile pattern gives the enclosure a finished surface once everything is fitted and sealed. After the old cracked shower area is replaced, you end up with a full shower enclosure that looks complete, contains water inside the space, and is ready to use for the next stretch on the road.
Ratings & Reviews
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.


Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.