Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
4-7/8" Round. LED porch light illuminates your RV's exterior with bright white light at a downward angle. Durable polycarbonate base and lens. Surface mount. 2-Wire pigtail. 9 Diodes.
Features:
Specs:
Surface-mount RV porch lights install using pre-drilled mounting holes in the housing. These lights lay flat against the RV surface and only require a small, often pre-existing hole, for wiring. Mounting hardware is used to secure the light to the RV.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today, we're taking a look at LED RV, Porch or Utility Light. This low profile round RV light serves as a porch or utility light for your RV or trailer. I already have it hooked up to power, so I'm gonna turn it on and then turn off the overhead lights. So you can see it in a low light setting. So you can see here it sends out a really nice, consistent signal. Nice, bright light output.
That is a LED system. LEDs make great replacements for incandescent lights. They last longer, burn brighter and they're more efficient.With LEDs you don't have to worry about replacing bulbs and you don't have to worry about brittle filaments. This unit contains a nice, clear lens. It's held in place with the included screws.
And then the base of the unit is a durable black plastic construction. Now I do wanna point out that this is set at an angle. So internally the LED board is set at an angle so that way when the light comes on, it actually takes the light and broadcasts it at a downward angle. So it's a really nice design. Very typical and common for porch lights.Surface mount installation.
So to gain access to the mount holes You need to remove the lens and then there's four mount holes on the unit. So that's directly to the surface of your RV or trailer. And that's a two wire design. So your white wire is your ground, black is for power. When it comes to the overall diameter, that gives us a measurement of about 4-7/8" and then the overall depth at the deepest point is about 2-1/8".
And then all of these mounting slots . Now it's a square mount pattern. So side to side, you're separated on center by 2" and up and down, they're separated on center by 2".That's gonna do it for today's look at the LED RV Porch or Utility Light.
Would it be too much for screews to be provided?
Great service and quality products
Outstanding service...have you in my roll X and will be using you for most all my items... Thank you very much..Roy
EAsy to install and bright as can be
Unable to review this item until I install product sometime in late July
Received early. Good products, great se rvice.
Very bright! I actually switched my amber lens into from my old fixture. Highly recommend!
Works well for outside light
Good price works well great company to work with
Used these to replace my outdoor speakers that had degraded to the point of having holes in the cones.
Would've given 4 stars if one of these had been fixed and 5 if neither were an issue.
1. No Lens screws. I get the mounting screws but come on is it too much to include the lens screws
2. In all my life Black has always been negative in a 12VDC system. Some reason these lights use white as negative and Black as positive. Despite what the video says polarity does matter when wiring these in.
Perfect match and fit for the original. Time will tell on quality. etrailer.com's service is awesome as always!!
My trailer did not come with a "porch light" and this caused problems when trying to unlock the door at night. It did come with other outdoor lights but they could only be switched from inside the trailer. We would have to leave them on all day on the chance we'd come home after dark so we rarely remembered to do so. This light has a switch so we can turn it on only when needed.
I TRIED TO FIND A LIKE REPLACEMENT FOR THE PORCH LITE FOR MY 1983BLUEBIRD WONDERLODGE. YOU'RE PRODUCT DID THE JOB .COVERED THE HOLES AND FIT PERFECTLY, LOOKS GREAT PROVIDES AMPLE LIGHT V SATISFIED.
When it rains hard, it comes on by its self ? Water gets to the switch. Would gladly pay more, for a better product.
Light was a expected. Works well
Nice and bright no mount screws no big deal
Ok for the price
Yes black wire is positive wire white is ground
I can find just about anything I’m looking for on the etrailer site. I’ve been happy with every item I’ve bought. I work in the RV industry for Holland Motorhomes and I know what I want. I can count on finding it on etrailer. Thanks to you for being an awesome company!!!
The product was what I ordered and an exact match. After installing we received two days of rain and now the light is lit all the time. I see water under the rubber switch cover.
We installed this on our 1999 Rialta as a porch light and it works very well. I would have given 5 stars if it came with a sealing gasket on the back side. We are very pleased with our purchase, keep up the good work!
Light works just fine. Should come with a gasket. Had to make one from an inner tube. So I dropped it by one star.
It fits perfectly, was easy to install and the light is very Brigitte.
Truthfully I was disappointed. Cheap flimsy plastic, was probably worth $[XX] or $[XX].
The product was just as described and a great replacement to the bulb style lights.
Do you have a question about this RV Exterior Light?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Peter
6/2/2025
Still works great. Pretty bright and angle is just right for a porch light.