Video Transcript for Review of Meyer Snow Plow Parts - Replacement Pin - ME42BR

Hi, everyone, Steven here with etrailer. Let's take a look at a replacement pin for the Meyer snow plows. Now folks, this is considered a one by three-inch pin. If your Meyer snow plow feels loose or doesn't pivot smoothly, lots of noise around land, a worn out pin is most often the cause. Now this one by three-inch replacement pin restores proper movement at the weight bearing joint, so that the plow can pivot and carry the load the way it should. So again, this will be weight bearing at that pivot joint, and you're going to want to get a pin if you don't already have it, or a clip rather.

That's part number 20420 sold separately. That's the clip that holds us in the place. This is made here in America, so it's a USA made part. It's also what we call a common wear item. So this is a replacement thing that you'll replace probably every so many years once those pins get worn, bent, missing maybe.

Again, they can fall out unfortunately and stuff. As far as the dimensions, so again, obviously, they're calling this a one by three. The usable length from here on the inside down to the center of the pinhole, you're looking at about 2 1/2 inches. If we go from the flat top here right before the pinhole, that's where you get that three inches that they're talking about. So again, from here right before the pinhole, that's the usable length and then obviously one inch thick.

So when you're measuring the one you have, if you have it, maybe you got a good one and you're just trying to match them up, it's about four inches overall, just so you're aware of that. But it is considered a one by three and that's where they're getting those dimensions from. Folks, that's going to wrap up our time together. I'm Steven. Thanks for watching.

.