Video Transcript for Detailed Breakdown of the Marshall University Chrome Buffalo Mascot Emblem 2" Hitch Cover

Today we're going to be taking a look at the Marshall University 2-inch hitch cover from AMG. The hitch cover's going to allow you to show your school pride with Marco the Buffalo right there on the front. It's going to add a clean finish look to your hitch and it's going to help keep dirt and grime out of the receiver tube of your hitch. The hitch cover is made from a steel construction. It's going to feature a really nice black powder coat finish which is going to offer great rust and corrosion protection. We're going to have the chrome plated metal emblem right here on the front.

It's going to feature a really nice rust-proof and fade-proof design. The product is American made. Here on the backside, it's got a foam gasket that slides over the shank. That's really going to do a good job at reducing rattling between the hitch and the hitch cover. This is an officially licensed product. To get it fully installed, it does require a hitch pin and clip or a hitch lock.

Those items are sold separately but if you are in need of one, you can them right here at Etrailer.com. The pin holes on the hitch cover will accept the standard 5/8-inch diameter pin. We're going to take some measurements here of the hitch cover face, start with the overall width. That's going to measure about 5 inches. Overall height is going to measure about 3 1/2 inches and the distance that we have from the back of the foam pad to the center of the hitch pin hole, is going to measure pretty close to 2 1/2 inches. Now this is designed for a 2-inch by 2-inch trailer hitch receiver.

Very simple installation, just slide it into the receiver tube of your hitch. Line up your pin holes and then secure it with a hitch pin and clip or a hitch lock. That's going to do it for today's look at the Marshall University 2-inch hitch cover from AMG.