A larger cruiser can have a roomy engine bay and still leave hoses exposed to cold air. This 800W bilge heater circulates supplemental warmth through the compartment, while the included fixed bracket holds it in place through winter.
A larger cruiser can have a wide engine bay, more hoses, and equipment tucked away from the hatch. This 800W heater adds supplemental warmth and uses a fan to move it through the enclosed space instead of warming just one spot. It's a starting point for many boats up to 35', but the space around the engines matters more than the number on the hull. Boats on lifts or trailers lose heat faster than boats in the water, and a wide or divided engine room may need another heater. Check for drafts, blocked airflow, and areas that warm air can't easily reach.
Once you've found a spot where warm air can reach the hoses and fittings, you may prefer to leave the heater there through winter. The included anodized aluminum mounting plate secures it with four screws, so it stays in one spot while you work around the engine. It's a fixed bracket, not a quick-release latch; if you want to remove the heater later, you'll need to undo those screws. You can mount it upright, sideways, or upside down. Keep the rear thermostat exposed to compartment air, give the fan a clear path, and mount above anywhere water might collect. If seasonal tool-free removal fits your plans better, compare the quick-release version.
You won't need to switch the heater on whenever the weather turns cold. Its thermostat cycles automatically, and a single LED lets you see what's happening when you open the hatch. Green means standby, red means it's heating, and amber means the fan is still running after the heat switches off. That fan may keep going for roughly 10 minutes to move remaining warmth through the compartment. The heater is intended for unattended automatic use when installed correctly, but it still needs power. After an outage or during a long freeze, it's worth checking the compartment.
Fuel lines, wiring, and pumps may all share space in a boat's engine compartment. This heater has an ignition-protected design tested to U.S. Coast Guard and SAE standards for areas where fuel vapors may be present. Its fully anodized housing and IP68 rating are suited to damp marine conditions, too. The 15' marine-rated cord has a grounded 3-prong plug, so there's no need to hardwire it. Use a properly protected outlet on a circuit meeting the listed 20A requirement, keep the plug connection away from water, and leave room for airflow.
Ratings & Reviews
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.

Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.