Most Popular Hitch Mount for Ram ProMaster 3500

Hang em High. Instalation time about 30 minutes with the help of my son 1 hour 30 minutes. He doesn't need to read instructions. He so smart. Well any way there is a bolt that bolts to the receiver note bolt to. It wouldn't fit so son decided to hammer it in. Guess what round peg square hold. Then son discovered it screws in and he has screw it up. After re thread bolt works great. Lesson don't let 52 year old son install with out reading instructions. This weekend I will mount the tire.

Only problem with the carrier is that I installed it on my Ram Promaster 3500 Van. You will need a 12”extension to push the carrier out so the back door will open.

Spare tire carrier is 5 star. The issue I have with the design is that it lowers the tow hitch by 2”. This drops the tow point for my toad to the minimum acceptable height and causes it to drag on the pavement often when leaving elevated parking lots. It would be great for Roadmaster to offer a design that would raise the tow point 2” to give purchasers the option to raise rather than lower the tow point. Tow bar manufacturer does not allow more than one connector between the tow bar and the motorhome, so device to raise the tow point is not an option.

I've used the Roadmaster Hitch Mounted Spare Tire Carrier for the last year (2023) and have put over 7500 miles on it. The carrier has performed seamlessly and is still manageable when mounted 40 plus inches off the ground. I have it attached to a Torklift 5' extension that goes into a 3" receiver welded into my flatbed. To prevent bouncing I've had Torklift put in a support bracket from the lower(regular) receiver. No bounce!

Just what I needed to mount the spare on my Class C with the Ford E450 chassis.

You guys are real problem solvers. I had my spare tire mounted on my lid closing the well which contains a great storage area for jacks and other tools and is lockable. However raising the lid with the spare on it became problematic for weight reasons and the spare would hit against the window and wouldn't open far enough to gain access. Wallah, the Curt Trailer Hitch Mounted Spare Tire carrier solved all those problems inexpensively and contributed to a overall better look for the spare. Thanks to everyone involved with the production and sales of this as it sure made my live easier.

This was exactly what we needed. It is very well-made and it sits nicely into the hitch with absolutely no wobble. The only reason I gave it four stars was because of the difficulty in aligning the bolts to attach the spare tire. They are free floating so they can be setup for a variety of tires. But this makes it very difficult to align the bolts and try to tighten at the same time. I solved this by making a paper template of the holes from my spare tire. Then I bought 3 jam nuts and 3 washers to secure the bolts into position before lifting the tire in place. Now that the bolts are secured in the right alignment it will be easy to remove and replace the tire in the future. It would be a very simple thing to add these instructions and supplies to the kit.

Well built, hard to lift 200LB tire and get the carriage bolts to align. The M12 retaining ring would not hold the bolts. Used a ATV jack to make slight lift and wiggle bolts into location. I'm 62 work smarter not harder.

Adam from E Trailer was great to work with. Directed me to the correct products. Placed my order and the items arrived within time they were supposed to. I highly recommend E Trailer. I have purchased other hardware as well as electrical wiring harnesses from them and everything has been as advertised.

Great build quality......works as advertized.