# 1
Thule Hitching Post Pro Bike Rack for 4 Bikes - 1-1/4" and 2" Hitches
Super sturdy and easy to use/install. Love the bolt hitch attachment, keeps the rack from swaying/wobbling. Attachment points are very solid and the anti swing clips keep your bikes from smashing into each other and the rack during fast starts and stops. I use for all types of bikes, road, mountain, cruiser, children's, etc.
The good: I like the way the bikes are held in and the ability to add the upright adapters to the bike frame holders. The straps are quality too. For a jeep with a spare tire, this is the perfect length to clear it. This rack is 5 stars from the bike holders to the base of it. The bad: the 2"receiver adapter and bolt are insufficient. I wish they made this in a solid 2" hitch. The entire setup is held into the receiver by a very short bolt. It only goes about half way into the receiver tube. So your hitch is only "secured" on one side. A hitch pin or bolt should go through the receiver tube completely imo so it can be secured on the other end with a retaining clip or nut. Because this only goes in the one side, the entire weight of the rack plus bikes are held tight to one side of the receiver by the undersized bolt and washer. A few bumps down the road and that bolt loosens. Now instead of distibuting the weight of the rack and bikes on the receiver and post, it's completely up to the bolt to keep you from losing the rack. The bolt threads get damaged too. I took this down a dirt road and nearly lost everything. I had to buy my own bolt with hd fender washers and lock washers to correct this. Thule should've provided this from the start. The current short bolt design where only one side of the receiver secures the rack is unacceptable. This rack is 1 star at best for the connection to the receiver.
# 2
Thule Passage 3 Bike Carrier - Trunk Mount
The side / bottom straps are seriously lacking. It has those straps you would find on a backpack, making it difficult to securely tighten down because of the angle. I'd usually have to pre-tighten them to a certain length, then forcefully shove the whole rack until it clipped onto my car. They really just need to be ratchet straps. Even then, one of the side straps came off while driving after hitting a small pothole and the whole thing dangled to one side - Luckily I was in a parking lot. I've also never been able to fit 3 regular bikes, only 2. It's really only a capacity of 3 if you have 2-3 slim bikes. The rubber is so wide that it makes it nearly impossible to slide certain bikes on. If you have a step thru bike with one of those crossbar adapters, I wouldn't even bother with trying this. Unfortunately I don't use this anymore since I'd be constantly worrying the whole thing will come off whenever I drive.
Fits perfectly on our Lexus CT200h. Only on the old LS400, the side straps have to be fastened to the wheel arch edge, since the upper trunklid gap is to narrow for inserting the strap hooks. Mounting of two bikes is (with some routine) quickly done, and they stay safe even for longer and faster routes. For transporting three (mountain) bikes, though, the design doesn't seem big and robust enough. Nevertheless, the price-benefit-fun ratios are way better than reasonable.
# 3
Saris Freedom Bike Rack for 4 Bikes - 2" Hitches - Frame Mount - Tilting
Great rack. I got a used unit from etrailer that was in like-new condition except for the packaging. It’s heavy-ish but manageable. The only issue is that the hitch tite insert will slide into the rack if you don’t keep it level when lifting into the hitch receiver. I’m using the freedom 4 on my Lexus GX 460, which has a swing out lift gate. Access is minimal with the rack level and the bike in place. It opens about 75% of the way with the bike removed and the rack level. I haven’t actually need to use the tilt function, but it’s nice to have in case need full access is ever needed.
WOW WOW WOW That is what I just kept saying after installing this Saris bike rack. I have been looking for a bike rack for almost 3-4 months now. Thule and Yakima didn't have what I was looking for. Their solution for a 4-5 bike rack is too complicated, not efficient, and it would be a nightmare to manage on a regular basis. So I couldn't get myself to pull a trigger on any of those and I kept searching. Finally, I came to eTrailer and found out about Saris. That is where the love starts :) We are a family of 5 (3 kids and 2 grown-ups). I needed something that will help me load bikes fast, unload them and still be able to have access to the back of my Toyota Sequoia. Saris delivered in every way. Assemble of the item is straight forward. Instructions are clear and to the point. They even give you a yellow strip that helps you mark where the hitch needs to be in order to align hole openings for easier installation after you install it the first time ;) The back-up camera is still usable but not 100%. Tilting down the rack with the bikes on it is simple as 1-2-3. There is plenty of room left between the trunk door and the bike as you can see on the pictures. One HUGE benefit is that you do not need any extra parts for kids bikes. Not like with other brands. Saris delivers tremendously on this part too. No shaking, rattling, or anything that would make you notice that you have this amazing product on the back of your SUV/truck. I can't recommend it more. I am just surprised that this product has not been more advertised and represented compared to other products.
What our customers are saying:
"Everyone that bought before me was right! I got my rack in time for my next days off and putting it together was fast too. And I'm a grandma!! Thank you for being fast and honest! You beat anyone in my town hands down!"