Most Popular Steel for 2021 Toyota Tacoma

It's a nice rack, sturdy and well thought out. However, the statement that it will fit a 2024 Toyota Tacoma is misleading. I did get it to fit, but it took a weekend of altering and fabricating parts. This is more a problem of the design of the truck than of the rack. The J-bolts are useless for this application. I had to unbolt the silly little plastic strip under the plastic rail on the truck and replace that with angle iron, then cut the rack's feet and re-weld some of the the round thingees where the J bolts would have gone through if the truck was built differently. Another option would be to drill and tap the metal rails under the plastic rails, but who wants to drill into a brand new truck? The etrailer people were super helpful but the Erickson people were not helpful at all.

Should work fine as intended. It is a bear to assemble. Tons of bolts I am worried will loosen over time. Just installed it today. Let’s see how it goes.

Install wasn’t horrible but I can’t imagine removing it often. The stops naturally don’t slide on the rail but can be relocated without tools which is nice. Seems sturdy. The cons, it’s steel and has started rusting after two weeks in places the paint wore off during install. I will have to clean it up and repaint it to keep it from looking horrible. In addition, the J bolts sit pretty far off the side of my 2007 F150 so the bracket is hanging off the rim inside about an invh. Once all together it doesn’t seem to matter but would be more comfortable if it sat tight. Overall, it gets the job done but if looking for pretty, get something that doesn’t rust.

The product itself is of good quality. It is a heavy duty truck rack. They say it is adjustable but that is only if you have the wrenches with you. It took several hours to assemble it alone. The bolts need to be a little longer especially on the mounting sleeves and the top of the cross bars. The sliding mounts were quite difficult putting on as the sleeves were very tight, I recommend WD - 40. When it was to the point of installing the cross bars it was necessary to loosen the mounting sleeves and move them. I called customer service and sent several e-mails and received no responses . I plan on using it to carry my kayaks while pulling a travel trailer.

great for my purpose

Delivery was fast as usual. The installation does take a couple hours and is much easier with a second set of hands. I have a drop in bed liner on my F150 so I did have to do some cutting but my oscillating tool made that a quick modification. Make sure to use the no seize on the bolts so they don't heat up when cranking them into place. Lastly, there are NO drain holes in the bottom of the tubes and believe me they do fill with water and ice in cold temps. I drilled two 1/2 in. holes in the sides at the bottom so they can drain but if I realized there were no weep holes I would have drilled a hole in the bottom of each before installation. After drilling the hole, make sure to coat with a primer and some paint to prevent rusting. Other than what I encountered they will serve their purpose and seem good overall.

I’ve been using this ladder rack for a year now and it has stood the test of time. I love the ability to remove the arms when I’m not using them so my tonneau cover can be closed. Highly recommended for the occasional need for a tough ladder rack.