Most Popular Best UV/Dust/Weather Protection for 2021 Jeep Wrangler

Excellent value for the price. Assembles easily and installs easily. Works and looks fine. Thanks again etrailer.

Hi, I received the product on time however, upon unboxing, I noted how scuffed and frankly dirty. The part was. I’m gonna still try to use it, but it was a little disappointed with this condition.

I have a 2018 Lance 1995. This is the right size cover for this trailer. This is a good universal type cover ,but it is not a custom fit. This cover looks like it will work fine, but since the trailer has a curved from section it does not fit as well in the front as it does in the back. I have had to use bungee cords to help take up the slack and make a area for water to drain off the roof. I had to decide to either cover the propane tanks or the read bumper. I chose the tanks. If you get the next size up there will be too much cover and you will have issues dealing with the extra material. This cover is just long enough to reach the bottom of the siding with no extra material. It was arrived quickly from E Trailer. I suggest watching the installation video. It was helpful.

2 people installed the cover today in a light wind. I am a mechanical designer. I am not receiving any compensation for this review. This is our first cover going on our first RV. We ordered/received the the 22' long cover for the trailer which measures ~22' bumper to hitch ball plus some for the spare tire on the bumper. I am happy with the fit though it looks like it would fit a trailer whose "box" is about 3' longer and still go over the tanks and spare tire. I thought the ordering instructions said to include the tanks in the front and the bumper/spare tire in the back when determining the length. There were no instructions except to "dull" sharp corners. The little foam tubes went on the gutter ends and I used black tape around sharp points on the bottom. The only bad thing about the cover are the buckles/buckles: they worked but 1) they are too light duty, too weak, and the sections too thin in my opinion and 2) the design stinks because I want to hold the female end right where you press to release the buckle which was annoying but I figured out how to do it and it was more awkward than it needed to be considering other similar buckle types. I got on the roof to pull the cover over from the side (not the front or back) over the ac, tv antenna, bathroom vent, etc and that worked well. It was too hard to pull the cover over the first top corner with me on a ladder and wife on the ground. If I could not get on the roof, we both would need to be on ladders. Or tie a rope to the straps and try to pull it over the top. Maybe try to pull it over from the front. The fit is very good: good width, more than enough length and good height. I am glad the height was no taller so as to keep it from wrapping around the bottom which is sharp and the trim ends are sharp. We connected the underneath straps first, then the front and back then cinched the top and bottom corners to pull the whole thing tight along the perimeter. All of the buckles are the same so I was able to repurpose some straps to wrap around the spare tire and bumper and connect to some other buckles for a better tie down arrangement. I would have liked a strap in the front middle to tie down under the tanks. Otherwise, there are just the right number of straps underneath. I don't think more would help and less would make me nervous. There are 2 flaps zipped on one side for a door at the front and/or the rear. I unzipped the front flap, sloppily rolled it up and attached the 3 velcro straps that hold the roll up. I had to undo 1 bottom strap from the flap so I need to rereview this after we have a good wind/rain storm but I think it will be ok. See pics. The trailer is parked in between a tree, shrubs, the house and the neighbors house so it is somewhat protected from some wind. Someone else may need to add a tie along the side bottom to take the place of the rolled up flap. When the flap is down, zipped, it is velcro'd at the bottom to the cover. The perimeter cinch straps have a sleeve layered on top of the sleeve the strap is in which is great for 2 reasons. 1) you can stick your finger in it to grab it to push the cover back and pull out the strap, then 2) you can regrab it while pulling the strap through the buckle and keep the stress off the strap. This will keep the strap from scrapping and wearing while pulling through the buckle. I took pics and a video of this. And 3), this is another sleeve you can run a line through if needed. Overall, I am very happy with this cover! It is reasonably thick material, aerated and the holes are covered with a flap to keep rain out, has a lot of straps which are well attached to the cover. The installation went better than expected at ~ 45 minutes and next time I expect to do it in half the time. The door access is a great feature. The cover went over the spare tire and the dual 20 lb tanks plus batteries in the front. One of the pics has the trailer model so you can see for yourself how well this cover fits this trailer. I expect this cover to last until a sharp corner some place tears a hole or the sun finally gets to it. The cover comes with a bag but I have not used it yet. And found a piece of velcro but not sure what for. PS: Finally looked at the storage bag and found the instructions, self adhesive material to fix holes and weights that can be attached to the straps to throw underneath the vehicle (not over b/c the weight could break a window or make a dent) in a side pocket.

The quality seams to be holding up after a year. I do believe that the design can be improved. The first I would like to see changed is the material. The cover is too heavy with no venting. I had to remove the cover because the coach got too hot inside.