# 1
Air Lift WirelessONE Compressor System for Air Helper Springs - Remote - Bluetooth - EZ Mount
Very easy to install,and works very perfectly
# 2
Air Lift Load Controller Compressor System for Air Helper Springs- Heavy Duty - Single Path
the compressor has every thing to install although i did not like the wiring harness,its 10 ga. wire with relay wired to power which could be ok because its switched through ground but to tie a 10 ga. wire to a fuse panel to me is a problem. i called air lift to ask about taking the relay wire out of harness fuseing it in panel and hooking 10 ga.to power no one could answer my question they said someone would call me no buddy did,i hooked it to power through a 30 amp relay works great
I was very satisfied with this air compressor system. I used it in conjunction with the 7500 XL airbags to support my fifth wheel RV. The compressor appears to be of exceptional quality, it was easy to install and came with everything I needed. I liked the idea of the remote air intake filter. One suggestion that would make to improve the function of the air compressor, would be to incorporate a time delay into the activation system. When operating the bags at minimum pressure, without the extra load, every time the vehicle hits a bump and the airbags expand, the compressor senses the decrease and pressure and applies more air. After a few bumps, the compressor has inflated the bags to a higher pressure than they would normally be in the empty state. This makes the vehicle ride a little bit rougher. The way I compensated for this, I installed an off-on switch on the compressor electric supply line. That way, when the compressor topped off the bags without a load, the pressure would stay stable and made for a better ride. Other than that, I am extremely happy with this compressor system in every way.
# 3
Firestone Air Command Heavy Duty Air Compressor with Tank - Analog - Single Path
The product seems to be great, I only have one problem, the 25' black air hose with fill connectors on both ends does not have any directions on how to connect to air pump its one lenght with no way to connect it directly to pump, any ideas or direction would be helpful, thank you Richard.
I recently purchased this compressor kit along with the AirLift Loadlifter 7500 XL air springs for my 2015 Silverado 3500. Installation for both is pretty straight forward but it did take me longer than I expected (about 8 hours total). They definitely help keep the ride height at factory designed levels & the auto leveling feature with the air compressor is excellent. I definitely recommend the wireless remote for the do-it-yourselfers as install doesn't require piercing the firewall to run wires for a switch. The wireless remote gives a digital easy to read screen that you can adjust while driving even. Overall I give this product a 5 star rating.
# 4
Air Lift Air Shock Controller Compressor System for Air Shock Absorbers - 160 psi
For the money, this set-up is hard to beat. I installed it on my 2002 Toyota Tundra TRD 4x4 along with a set of Firestone Ride-Rite airbags to aid in leveling out the truck when pulling large trailers. I ran into some issues installing the supplied gauge panel- in the tundra there is litterally no place to mount the panel aside from the dash pocket on the driver side. Unfortunately, this pocket houses my electric brake controller as I like it close by in case I need to manually override the brakes by the lever on the unit. My solution was to remove the lower, center dash panel and cut the holes to house the gauges. This proved to be no simple task as the srs airbag pcm is located right behind this panel- i had to trim the pcm mount, elongate the mounting holes in effort to slide the srs pcm back enough to allow clearance for the gauge. I also ended up using an angled trim from auto meter to aid in this as well. When wiring the lights for the gauge i tapped into one of the illuminated trim rings for the factory power outlets- this allows the gauge illumination to only come on when the headlights are turned on. I decided to mount the actual compressor under the center of the bed on a support rail using a custom bracket made of 1/8" steel plate as there is really not much room for it in the cabin and my storage cubbys under the seat are already full. The only downside to this compressor is that it takes a good while to reach 100 psi on the gauge. This is why I rated 4 stars instead of 5- Im sure the addition of an air tank would help tremendously. FYI- Fastenal carries the proper push fittings for 1/4" air lines- i needed two extra tee's (about $20 for both) as i wanted schrader valves to remotely fill it if the compressor decided to give up the ghost.
Fantastic information and service, very satisfied
# 5
Firestone Air Command Remote Filling Station - Heavy Duty Air Compressor with 3 Gallon Tank
What our customers are saying:
"Quick processing, and delivery. reasonably priced very satisfied"