Most Popular Fixed Step for 2019 Honda Ridgeline

It is all plactic with medal inserts where the holes are that the hitch lock goes through. The bolt they sent was to short. Just a peice of junk for $[XX] bucks. It will not last long.

My wife wanted something that would help her step into our Travato motorhome via the back door. It's built on a RAM Promaster and entering through the back doors requires a pretty good step up to get in. When I saw the BumpStep, it looked like it would make getting in easier, so I figured I'd give it a try. It arrived this morning, took about five minutes to install using the included hardware and it works even better than expected. The only thing you need to install is a 15/16" socket. The step is super sturdy and makes it so much easier to step in and out of the van through the back doors. Would highly recommend.

Click to Enlarge

Nice looking bumper step, not too large and no interference with the vehicle backup sensors. Lower step for access to storage and also protection for the bumper from other cars that get too close.

Click to Enlarge

Click to Enlarge

Click to Enlarge

Do not buy a locking pin. I bought one and after almost a year could not fit key in. Had to rent a truck as time was of the essence.

It arrived a day early! Bolted right on in a few minutes, the nuts are set in, so no need for a wrench on them, just the bolt. I run without a tailgate as I put my bicycles in the back so this step is PERFECT. I have a slide in camper, so, no tailgate. I pull a fifth wheel, so, no tailgate. Step on the step, then the bumper and safely into the truck. I already had the hitch, so this bolt on step makes the costs low.

Click to Enlarge

The mounting hardware was loose in shipping box. I know it's made to mount to a reese hitch, but I installed it onto a kurt hitch seems to work well and is a quality product.

It’s a great step not too big and not too small and it looks great.

Click to Enlarge

Click to Enlarge

Love it nobody is tailgating

Great craftmanship...worth the money!!

The step is great. Welds are very professional. I would say the instructions need to be clearer. It has you putting the end caps on the step first , which should be your last step. You should assemble the plate and hitch 4 bolts and fasteners. Then loosely assemble the side supports (4 bolts and fasteners)so the step slides between the plate and end supports. Tighten the the end supports down. This holds the step in place otherwise its a loose mess waiting to come off. Lastly, attach the endcaps with screws. The video literally states the step is sandwiched between the plate and side supports, but following the 3 step instructions , you will not achieve this result. Please review your instructions.