Most Popular Alignment And Lift Kits for 2017 Chevrolet Silverado 2500

Very easy to install. Be sure to weld the top of the axle as stated.

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

The lift worked out perfectly,I had the place where I bought the trailer install them because I didn't have a welder to weld the saddle mounts to the axle and that's a must for a safe installation,also I had the place where I bought the trailer do it because they had the capability to align the axle perfect to the trailer after the installation. The lift added approximately 5 inches to the trailer hight so I could install the off road wheels and tires.The lift didn't affect the handling of the trailer at all.

Click to Enlarge

Click to Enlarge

Great kit! Installed this on my 1995 Jayco Fifth Wheel and it really improved the ride height with my truck. It’s been on 2 round trips from Texas to Montana since and many other trips locally with no issues.

Click to Enlarge

Click to Enlarge

Click to Enlarge

Our trailer was so low...that it could not make it up a low curb and some driveways - especially when fully loaded. Went with the Dexter axle flip kit. The Dexter bracket and base plate pieces are worth the extra $20-$30 compared to other similar kits - they make fitment easier, eliminate any guesswork on placement, and decrease installation time because of it. Took 2-3 relaxed pace hours for us to do single axle install. Tools required were ratchet/wrench set (13/16 deep socket worked for us for most of the bolts), cheater bar (for working those rusty bolts off), drill, angle grinder (cutter disc for oem u-bolts and leaf spring bolts that are rusted or welded in place, stripper disc for cleaning area around new bracket for welding) welder, floor jack and jack stands. We had to remove the leaf springs, as the wheel mount brackets would not fit through the openings. Was hoping we wouldn’t have to, but it was pretty simple to do. We jacked the trailer up. Removed the wheels. Removed the axle. Cleaned the axle area where new brackets go. Set the height and placement of the new Dexter brackets. We left the OEM brackets on the axle and placed the Dexter ones in the exact same position 180 degrees on the other side. Welded them on. Reinstalled leaf springs. Reinstalled axle, reinstalled wheels. Then voila! We added 6 full inches of height. Super awesome.

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

I used these in a welded application. My axles were welded in place. Once the axles were cut free, I aligned and bolted the brackets in place, welded the axles back on. Gained the clearance I was after to give bed rail clearance with the gooseneck as well as give more even axle weight distribution over both axles. Sure a bolt and play scenario would have been great but sometimes you have to make work with what you’ve got. Turned out great!

I used these in a welded application. My axles were welded in place. Once the axles were cut free, I aligned and bolted the brackets in place, welded the axles back on. Gained the clearance I was after to give bed rail clearance with the gooseneck as well as give more even axle weight distribution over both axles. Sure a bolt and play scenario would have been great but sometimes you have to make work with what you’ve got. Turned out great!