# 1
Adapter 4 Pole to 7 Pole and 4 Pole w/Test Lamps
Perfect . My new Subaru hitch has a flat plate to which the dealership attaché the 4-flat. I used “2 L-brackets” to accommodate the 90 degree bend of the adapter bracket.
I recently had a receiver hitch installed on my 89 Silverado and the wiring was merely zip tied to the safety chain connection. Well that didn't sit well with me. I wanted a more permanent wiring connection point. So I purchased your 4 flat to 4 flat and 7 way plug and installed it. So far so good. The installation turned out perfect and it looks good. The test lights are a great thing as well. I couldn't be happier.
# 2
Curt Universal Installation Kit for Trailer Brake Controller - 7-Way RV - 10 Gauge
Should come with the 7-pin mount for the vehicle. Hence the 4-star review. Part is well designed and fairly easy to install.
I ordered this wiring kit for a 2003 Dodge Ram 1500 I recently acquired. The Ram was not tow ready but did have a factory 4-way. I also ordered hitch #13333. The wiring kit is very high quality and was easy to install. The 7-way fit perfectly where the factory 7-way would have gone. I'm using a Tekonsha Prodigy RF wireless brake controller so the blue lead was not needed but I left some extra should that change. Thanks etrailer!
# 3
Curt Trailer Connector Adapter with Backup Alarm - 4-Way to 7-Way RV and 4-Way Flat
Good product and install instructions. The only complaint is the 4 pin connector falls out of the housing.
Exactly what I was looking for. Easily connected to my existing 4-way without any additional wiring. The 7-way adapter bracket was the correct size, and the holes were pre-drilled for the right fit to connect to the existing bracket on the (U-Haul Installed) tow bar.
# 4
Curt Trailer Connector Adapter - 4-Way to 7-Way RV and 4-Way Flat
This was very plug and play. As always mounting is usually the tricky part from one install to another from my experience. I was able to mount mine on my Jeeps factory bumper via some larger holes that were in the bottom of the bumper. I used some fender washers an a metal backing plate for my particular install.
The pictures show the harness 6 months after installation. Due to steep driveways and my wife’s driving; it got bent from its 90° angle. Despite the damage, the harness still works correctly and reliably. 10/10 would buy again…may have to if wife keeps driving.
What our customers are saying:
"The sales associate I spoke with was very, very helpful. I know very little about cars/trucks and, in my opinion, he went above and beyond to help me determine what I needed to buy! Thank-you so much for your help and especially for your speedy shipment! : I will definitely buy from this company again."