# 1
Draw-Tite Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 8-1/2" Long - 7.5K
The hitch was very easy to install, took about 30 min. It fits perfectly to my 2001 Ford Ranger. The tow bar is very sturdy and is very well made! The delivery was fast, I ordered it on a Monday, and it arrived on Friday. I would most DEFINETLY recommend this to anyone who is considering this for a tow bar.
I had a hard time deciding on the amount of drop and the length of the hitch ball. The etrailer website provides sufficient information to allow an educated selection. I found this ball mount to fit easily inside a 2" receiver without too much free play. The hole placement gave just the amount of extension I wanted so that I can walk around the truck without banging my shins yet still have sufficient room to allow the trailer to be hitched easily.
# 2
Draw-Tite Ball Mount for 2" Hitches - 2-3/4" Rise, 4" Drop - 9" Long - 7.5K
To be honest, I use it upside down. I needed a hitch with rise, but none were available at time of purchase, and yours, inverted, works perfectly! The welds are regularly checked and remain all secure. It's a good hitch.
Working in the sand and grass of my driveway my wife and I installed our new etrailer receiver hitch. Great fit and finish! Went right on as described in the online guide. Hitch required a spacer washer on top back bolt attachment point. Taped it on so it would not move while lifting in place and it stayed right there! Used a car jack to raise up and hold the hitch into the underside of the trunk tighten the bolts and reattached the tail pipe done. Now we can pull our Sunfish Sailboat any where the car will go.
# 3
Draw-Tite Ball Mount - 9-3/4" Rise, 11" Drop - 9" Long - 3,500 to 5,000 lbs
Great product and great service. Etrailer stands behind their products!
Basically I bought this ball-mount after I installed the low-slung hitch receiver from ETRAILER to know I have an ability to haul something if really needed in an emergency situation. The receiver hitch was purchased for my Thule bicycle rack , purchased from Etrailer.
# 4
Draw-Tite Ball Mount for 2" Hitch - 7" Rise, 8" Drop - 9-1/2" Long - 12,000 lbs
It fits perfect on my f350 diesel, super heavy duty. I'll be using it for towing my car tilt bed trailer.
Heavy Duty Drop Down Hitch no problem pulling a 10,000# trailer
What our customers are saying:
"Very helpful/friendly Customer Service. Competitive Pricing. Shipping was Fast."