# 1
Hopkins Endurance, Flex-Coil Trailer Connector Adapter - 7-Way to 5-Way or 4-Way Flat with Nite-Glow
Great product. We used it with our Toyota 4 runner to tow our boat. Since the Toyota 4 runner electrical plug in is so far behind the rear bumper, we needed this extension in order for there not to be any issues with the wiring for boat trailer to become disconnected from being too short. The cord being coiled allows the extension to be as long as needed without possibly being drug on the ground.
The product itself is of sturdy weight and production. BUT, the product description says 0-5 feet in length. It would difficult to stretch this product to 5 feet and not have it unplug itself on a bumpy road.
# 2
Custer Trailer Connector Adapter - 4-Way Round to 4-Way Flat
ITEM ON ROUND END WAS LARGER THAN ROUND SOCKET ON TOW VEHICLE. DIDN’T FIT.
Great product, just what I ordered. I couldn’t find this adapter anywhere else until I came upon it at etrailer.com!! I have ordered other products from etrailer and have been completely satisfied with those products as well. Thanks.
# 3
Hopkins Trailer Connector Adapter - 7-Pole Round Pin to 7-Pole RV
Product won't work correctly. I've tried it with 2 different trucks and 3 different trailers. Each Turn signal will active the hazard lights, and no tail lights. When pressing brake lights, all side marker lights will light up.
Well made is all I can say about this adapter only because I used it once it worked out great but have not had a need to use it again. I keep it with my other towing plug adapters as I'm sure I will need to use it again someday!
# 4
Hopkins Endurance Easy-Pull 4-Flat Extension w/ 1 Grip Ring - Vehicle and Trailer Ends - 12"
Great product great service!
The wiring on one of my trailers was a little tight. This is a great wiring extender. The ring is easy to grab especially if hook-up is a bit inconvienent.
# 5
Pollak Trailer Connector Adapter - Vehicle End - 7-Pole Round to 7-Way Blade
I received this item in a plastic bag, for a few moments i wondered if it was a knock-off. I had done my home work and was sure that this item would be compatible with the socket on my John Deere 2013 5085M at the time I ordered it, not so. The 'holding ridge' at the plug-in end was not in the right position when fully inserted into the plug on the tractor. I sent multiple pictures to Pollack Technical Support but they were unable to assist me. I finally modified the item myself (something I really hate to do) so that it would fit the plug-in and be 'grasped' by the cover/holder on the tractor side. As I anticipated, the thickness of the plastic was inadequate to make the adaptation 'sweet', so I had to cover the resulting hole with silicone caulk.
This is a great solution for adapting RV blade connector to 6 pole connector. I give it 5 stars. I use this for work purposes, and have found one issue that I DON'T believe to be manufacturer defect. In my industry we use different trucks and trailers daily, if not hourly. Some trailer electric brakes will lock up when adapter is connected. I have found the red wire in the adapter to be the problem. My solution was to splice in a switch so that when the intermittent problem arises I can flip the switch and be on my way.
What our customers are saying:
"You folks are fast. Thank you very much."