Most Popular - 4 Inch for 2010 GMC Terrain

Videos extremely helpful.Product was all and even more than expected. The hitch went on without a HITCH, Sorry, couldn't help it. this is how it turned out. would buy again in a heart beat. Thanks

To be honest, I use it upside down. I needed a hitch with rise, but none were available at time of purchase, and yours, inverted, works perfectly! The welds are regularly checked and remain all secure. It's a good hitch.

Excellent service,order arrived quickly.

Love these. This is my third one. Wouldnt pull a trailer with anything else. Trannys are expensive.

works well brings the trailer tongue up to level. I have it on an EV so the raddle is annoying, because I just keep on forgetting to buy a anti rattler.

This is very sturdy hitch. It is made of solid steel, not tubing. It will be used on my Mazda RX-3 to tow my car dolly to the RV lot where I will swap everything around and the car will end up on the dolly behind my RV.

Purchased because I wanted something that looked a little better than the standard black ball mount and couldn’t find the size I wanted in aluminum. I used it 3 times last season and put it away for the winter in my garage. It was never on the truck while salt was on the road. Pulled it out the other day and it is a disgusting rusty mess. Attempts to clean off the rust were unsuccessful it was that bad. Total waste of money BTW the picture is post cleaning, it was even worse before

Great looking Piece for something made in China.

Used on my 1999 Dodge Intrepid's CURT 12006 Class II 1.25 in. Receiver Hitch: 350lbsTW/3500 lbs GTW. I use this Curt Class II Drawbar - 3-7/8" Rise - 11-1/4" Long - 3,500 lbs to tow a 3,500+ GTW dual axle trailer. I have used it with the trailer FULLY loaded and it performs EXCELLENT. You have to make sure the trailer is loaded correctly so as not to put too much down force on the tongue/drawbar. I was skeptical that the SOLID 1.25" bar would not take the load, but it is super strong. I chuck it in the trunk when not in use to protect passerby's shins, but it sticks out far enough clear the Intrepid's bumper, and is solid with a 2" ball (required a bushing). etrailer got it out fast at a good price! I would totally purchase this again from them.

Simple as a hammer. Solid steel and quite heavy duty for the intended class.