Most Popular TorkLift for 2001 Nissan Frontier

Having been in the auto/truck repair business for over 50 years, I thought this would be a good Idea so I tried it. I could have made my own but it would be a lot of cutting and drilling because it is so many pieces. I used it to add capacity so I could haul my camper that I purchased three states away and had to pick up. I used 2 of the 3 plates because there wasn’t enough room for three. It did very well like that but after I got back I added the 3rd plate figuring I could use the third one by just jacking the truck slightly before engaging. I thought all three woul be needed once the camper was full of water and gear. I am enclosing a picture of how ti drill the springs with using the vehicles own drill press (screw jack) for changing tires. I still need to test fully loaded and with all three plates in place.

The front brackets did not fit my stock 2005 F3 15 the down rods for the anti-sway bar were too close to the leaves springs to allow clearance for these stable load additions. Customer Service told me that they have never seen this problem before, that is hard to believe with all of the F350s on the road. However, I was told that I could use the rear plates on their own.

Really like Torklift products but should have passed on this one. After 1.5 hours of driving a pothole and washboard logging road, got home and found the bolt going through one of the leaf springs had snapped. The only thing holding the part in place was the remains of the bolt. Have since replace the bolt but will remove this product in the near future. Had this part fallen off on the HW it could have caused serious damage to a following vehicle. Sorry Torklift.

My review is specific to the Stable Loads for my 2014 Ram 3500 SRW 4x4 Diesel Pickup truck. First, the package arrived a day ahead of the delivery schedule. Inventory of the kit showed it was complete and matched the list of contents included. The overall impression was that this is a very well made and manufactured system. The stainless steel option seems to be well worth the small added cost. The instructions from TorkLift are a little vague in places so here are a couple of pointers. First, I needed more spacer washers than were provided with the kit due to the thickness of the lower spring. I was short a total of 4 washers. It seems like this is a simple detail that others should have made TorkLift aware of. Surprisingly, I found no mention of this on-line or in videos. Another vague area is regarding the orientation of the bracket on the spring pack itself. on my truck, I needed to install the stable load to the inside - between the frame and the spring. I tried to install the rear stable load to the outside (tire side) but found that even with stock size tires, the clearance was too close for my comfort (less that 1 inch between the bracket and the tire sidewall. On my truck, there is a wiring harness along the bottom of the frame at the rear drivers side that had to be adjusted closer to the frame to provide clearance for the bracket. Otherwise, all 3 of the other mounting locations had adequate room for the inside mounting location. Also, for my truck, using two of the three wedges provided the right thickness for proper engagement. Another note is that for my Ram, I did not have to drill out the springs because the rubber pad is installed into a hole on the overload spring. The hole is slightly larger that the diameter of the mounting bolt. This did not seem to affect the installation but again, it seems a bushing of some sort would be a good addition to the kit. Installation time was a bit longer that what I have seen mentioned by others but still, a few hours and it was ready for a test drive. With the stable loads engaged, the empty ride is a bit stiffer that stock but not objectionable. The real test will be with the 3000lb+ camper installed. That review will have to wait. E Trailer was great to order from and had the best price I could find on-line. This is the 4th or 5th time I have ordered from E Trailer and have never been disappointed.