Most Popular Aluminum Shank - Silver for 2000 Chevrolet Avalanche

Very strong, easy to install and very secure. Yes a bit pricey, but well worth the money. I did notice there was what I thought was an unusual amount of play in the receiver. I called etrailer and Marcia was so very helpful and very concerned that I may have received the wrong product. She even called the manufacturer and found out what the changes that were made by the manufacturer which made the pictures incorrect. My hat is off to Marcia and all the folks at etrailer

Click to Enlarge

ball mount fits loosely in the receiver so that the pins that extend out from the ball mount shaft through the holes in the receiver don't extend out far enough, for my liking. This is because since the ball mount shaft has so much play, it will shift to one side. Then, the pin on the other side does not extend all the way out of the hole so that it is not flush. True, i am being paranoid. However, i imagine a case like a crash where enough force could pull the shaft out from the not fully extended pin side to release the trailer to wreak more damage. I would just feel more secure if the pins went out further through the receiver or the shaft was not so loose. Otherwise, i really like the product a lot... enough to give it four stars... :o)

Will be using to tow five different trailers with new truck. Appears well made. Should provide the flexibility to use one hitch, instead of switching between multiple drop lengths.

Bought this hitch to tow my camper with my new 1/2 ton truck. Hitch was a little hard to get adjusted, but that could be i had never done it before. After watching several videos i got it close. I dont think it's perfect, but does its job. Only made 1 trip using it, but it was a 900 mile round trip. Didn't have any problems with sway, and hitch is very quiet when turning. Overall very good purchase hopefully get to use it more in the future.

Hello The hitch works great as viewed in the enclosed pictures. If inverted it hits the bumper, of my Dodge 2500. The section that goes into the receiver is about 1/2" too short and hits the bumper. I have not tried it on my other vehicle to see if this is a problem. Kind Regards Leon D

Click to Enlarge

A VERY nice piece that will set your mind at ease. Easy to adjust height. The ONLY thing I wish is there was an option to have different sized ball combinations. I mainly use 2" and NEVER use a 2 5/16"(or whatever the larger size is) and would prefer to have a 1 7/8" on the other side.

Click to Enlarge

Sooooo....you sent me a product that was somehow put together backwards and I cannot take them apart somehow the ballhitch is stuck on the male portion backwards and defies gravity and doesn’t need a pin to stay on(becaue thier is no where to put the pin in cause it’s backwards

Click to Enlarge

Fast, helpful, prompt service on great and helpful trailering products. Thank You