Troubleshooting No Power on the 4-Way Curt Harness part # 56094 on a 2008 Chevy Equinox

Published 05/21/2014

Products Featured in This Question

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(1014)

$30.31

Hook Probe Circuit Tester

(58)

$12.08

Question:

There is no power to the plug. Do I need to add some fuses or circuit breakers?

asked by: David F

Expert Reply:

If you tested the 4-way of the Curt Connector part # 56094 with a circuit tester like our part # PTW2993 and got no power out of any of the pins with the different taillight function applied the first thing I would do is make sure you grounded the white wire of the harness to a clean metal surface that touches the vehicle frame.

The next thing I would do is make sure that all of the connectors are securely in place. You could even unplug them and then replug them back in. I attached an install video for you to check out also. Are the vehicle taillights still working? If not, then a fuse is most likely blow and will need to get replaced. There may have been a short on the trailer that fried this circuit. I would recommend fixing the short before replacing the fuse as it would keep popping that fuse.

I also attached an FAQ article on troubleshooting 4-way installs for you to check out.

expert reply by: Jameson C