Drilling Out Hole to Install Sealed 2 Inch Round Trailer Clearance and Side Marker Light MC-53RB
Updated 04/07/2014 | Published 04/05/2014
Products Featured in This Question
Question:
hello I have seen previous comment that a 2and5 16th hole is needed to mount the 2 inch marker light. I cannot find a 2and5 16th hole sawbit. Will another size work? all I can find is a two and 1/2 inchor a 2 inch. they are about 20 bucks apiece so I dont want to have to buy 2. Thank you
asked by: Rolan
Helpful Expert Reply:
A 2-1/2 inch hole saw would be too large for a 2-5/16 inch hole. So I recommend going with a 2 inch hole saw and gradually enlarging the hole with either the same hole saw or a rotary tool. Then you can do some test fits with the light until you get the hole just the right size so it fits.
To make sure you have the hole the right size you will want to first place it in the grommet, # A54GB, and then in the hole. Otherwise, if you just used the light or the grommet you would not get an accurate measure of if the light will fit or not.
This light also uses pigtail # A46PB. Black is the power wire and white is the ground.
Product Page this Question was Asked From
Optronics Trailer Clearance and Side Marker Light - Submersible - Incandescent - Round - Red Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Round
- Recessed Mount
- Submersible Lights
- Incandescent Light
- 2 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Q&A: What Size Hole is Needed for Installation of 2 inch Round Trailer Clearance Light MC53RB
- Q&A: Recommended Hydraulic Brake Hubs that Work w/ 10" Wheels
- Q&A: Is Powder Coated Wheel or Galvanized Wheel Better for 205/65-10 Trailer Tire
- Q&A: Correct Replacement for Peterson 410-25 Trailer Tail Light
- Q&A: Possible Replacement for Trostel 300-156-6 Seal
- Q&A: Troubleshooting Loose Gooseneck Ball on 2019 Ram 3500
- Q&A: Recommended Replacement For A JVR9000R RV Stereo System With Three Cameras