Wire Gauge to Use Between 3000 Watt Inverter and AC Panel

Question

Question:

What size wire and type, stranded or solid should I use between a 2000 or 3000 watt inverter to my AC panel ?

asked by: Sam H

0

Expert Reply:

For a 3,000 watt inverter like the # 34275013 it's recommended to use 1 or 0 AWG between it and the panel. Solid or stranded is fine.

expert reply by: Jameson C

0

Answer 1

We have just what you need, the Go Power Portable Solar Panel with Digital Solar Controller, #34282610. This lets you place the solar panel where you need it for maximum sunlight while not having to place the camper in the sun too. For the later…

view full answer...

Answer 2

The Go Power 100-Watt Solar Flex Kit #34272630 includes a digital controller and so does the 80-Watt Eco Kit #34272627. Since you need only one controller I suggest adding the expansion panel to avoid having duplicate parts. You can use the Go Power…

view full answer...

Answer 3

For a 30-Amp service RV with the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger, #PD4045KA installed, I recommend the 1,000 Watts - 12V Progressive Dynamics Pure Sine Wave Inverter w/ Transfer Switch & Remote, #PD94FR. I…

view full answer...

Answer 4

I wouldn't let the controller of the Go Power Portable Solar System with Digital Solar Controller #34282610 get submerged in water but it would withstand rain. You'd want to use your best judgment when mounting the controller to limit…

view full answer...

Answer 5

I recommend using the Go Power Industrial Pure Sine Wave Inverter Charger #34275013. This will reduce all the components into one system by combining your transfer switch inverter and converter/charger into one unit. You will be able to wire in your…

view full answer...

Answer 6

Hey Don, thanks for reaching out! The Furrion Chill Cube #FR99TD does have provisions built in to lower the amount of power required to start the unit up. I don't think Furrion officially calls it a soft start (there's debate about that…

view full answer...

Answer 7

Since they didn't list the converter amperage rating on your panel you'll have to just choose the amperage your battery bank requires and then do a bit of investigative work to ensure that the wire gauge used for the converter is enough to…

view full answer...

Answer 8

Hey Renzzo, We can definitely get you setup with what you'll need but we'll need to figure out your power demand and available space in order to pick the right kit for your needs. I would start by listing out every electrical…

view full answer...

Answer 9

Hey Dave, we can definitely help but we don't have any kits that work as both trailer wiring and tow bar lighting for your 2024 Ford Bronco so you'll need to install both kits separately. But they will work fine together. For tow bar lighting…

view full answer...

Answer 10

From what you have described as your goal, my suggestion is one of two primary options, and I will note here that with either option I suggest you have a battery bank of at least 400 AH when fully charged. This first option is not an automatic…

view full answer...

Answer 11

For your 58 inch Lippert Edge RV awning the correct replacement idler arm is the part #LC62ED and the correct replacement drive arm (one with the motor) is the part #LC22ED.

view full answer...

Answer 12

Since the system was already working and all of sudden is causing issues for you I suspect that you may be pulling too much solar power for your battery bank causing an overcharge error or a separate system, like your alternator is also charging your…

view full answer...

Wire Gauge to Use Between 3000 Watt Inverter and AC Panel

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching