Does the Bumper Fascia Need to be Trimmed to Install a Curt Hitch on a 2013 Porsche Cayenne
Updated 02/27/2013 | Published 02/26/2013
Question:
Your video shows above hitch installation on a VW Tourag. When installing on the Porsche Cayenne does one have to cut an opening in the Cayenne bumper shroud? If so is there a template or detailed instructions on that procedure? Any info specific to the Cayenne would be appreciated.
asked by: Sam T
Expert Reply:
I spoke to my contact at Curt and he informed me that you will not need to cut an opening in the rear fascia to install the Curt Trailer Hitch Receiver # C13116 on your 2013 Porsche Cayenne.
I attached installation instructions and video for you to check out also.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 750 lbs TW
- 7500 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: How to Change 4-Flat to 5-Flat on 2011 VW Touareg for Boat Trailer
- Q&A: Trailer Hitch Comparisons for 2016 Porsche Cayenne
- Q&A: Best Trailer Hitch Receiver for a 2018 Porsche Cayenne E-Hybrid
- Q&A: Why Does 2015 Volkswagen Jetta TDI Use Different Trailer Hitch Than 2015 Jetta Non-TDI?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Differences between Class III and Class IV Hitches
- Q&A: Recommended Trailer Hitch for 2017 Porsche Cayenne S E-Hybrid
- Article: Trailer Hitch Installation Tips
- Article: Specialty Trailer Hitch Review
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: 2005-Current Volkswagen Touareg, Audi, or Porsche Cayenne
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Choose the Right Trailer Hitch Class