Vehicle Suspension Specs:
Features:
These drag bags are the perfect racing accessory for your vehicle's rear coil spring suspension. The molded polyurethane air springs fit inside your existing coil so you can pre-load your suspension to balance tire loads and improve launch times.
Installation Notes:
Drilling required for installation
More Information >Vehicle Suspension Specs:
Features:
For safety and stability, air springs are the perfect partner for your rear suspension when you are hauling heavy loads. Springs fit inside existing coil springs to help level your vehicle, improve braking and handling, and reduce tire wear.
Installation Notes:
No drilling required for installation
More Information >Vehicle Suspension Specs:
Features:
1,000-lb Capacity. Upgrade your vehicle's rear coil spring suspension with this kit. Molded polyurethane air springs fit inside your existing coil springs for added support when hauling heavy loads. Improves handling, braking, and overall ride.
Installation Notes:
No drilling required for installation
More Information >Videos
for Vehicle Suspension
Help Articles
for Vehicle Suspension
Expert Answers
for Vehicle Suspension
Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit…
view full answer...For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the…
view full answer...It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression…
view full answer...Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be…
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…
view full answer...What…
view full answer...In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
view full answer...Your trailer looks awesome! The Road armor equalizers #LC696740 and Equa-Flex Cushioned Equalizers #LC279687 are both pretty similar in performance even though the Road Armor has two dampers. The main difference is the size of the equalizers. The…
view full answer...From what I could find it looks like your 122R (red) and 122Y (amber) lights measure…
view full answer...I do have an option for you, but we do not carry the Dexter 072-027-00 you mentioned. However we do have the etrailer Double-Eye Spring for 7,000-lb Trailer Axles -…
view full answer...If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…
view full answer...For a standard replacement equalizer for your Dexter 13-122 equalizers…
view full answer...Filter Products (6)
Contact and Help
What our customers are saying:
I like the easy of navigation through the site. It only took me a couple of minutes to place my order. Thank You I will shop this sight again in the future.
Kevin
Manchester, MD