Where Does the TorkLift HiddenPower Under-Vehicle Battery Mount Install  

I spoke with my contact at Torklift about your 2013 Ford Super Duty truck. Since the TorkLift HiddenPower Under-Vehicle Battery Mount, part #TLA7728 will only mount in one location, you would be limited to 1 on your truck. This comes with the…

I was able to take a picture of the instructions for the Truck Bed Cargo Camera for 8" Factory Monitor - Switch Kit #3460006 that you referenced. The camera unit actually has a "T" harness that will send the video feed…

Yes, the DuHa Storage Box and Gun Case part #DU20054 does fit your 2011 Ford F-Series Super Duty that has a factory storage compartment under the seat as well. We checked with DuHa to confirm this as well.

The Truck Bed Cargo Camera for 8" Factory Monitor part #3460006 which is a fit for your 2016 Ford F-350 will only draw around 0.3 amps. I spoke with GCH and they recommend that you use a 3 amp fuse for the switch. If you cannot replace one…

The Custom Third Brake Light Camera for 8" Factory Monitor part #3460006 which is a fit for a 2015 Ford F-350 does come with a switch that can be substituted for a switch of your own such as a pre-existing upfitter stitch. This was been…

Yes, I checked with Torklift and the TorkLift HiddenPower Under-Vehicle Battery Mount with Battery Box #TLA7728 that you referenced would be a confirmed fit for your 2008 Ford F450 as long as it is a long bed. I attached a link to installation…

While we don't have a specific location we've tested on your 2018 Ford F-150 for mounting the tank and compressor of the Air Lift QuickShot Kit part #AL25690 that you referenced I can give you the recommendations that Air Lift makes…

To see where the TorkLift HiddenPower Under-Vehicle Battery Mount with Battery Box #TLA7728 that you referenced will mount check out the picture I attached. It basically will attach to the passenger side frame rail just to the front of the leaf…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…