2007 Acura MDX Air Filter

The Easy Grease Trailer Idler Hub Assembly for 3.5K Axles part #AKIHUB-545-35-G-EZ-K is a direct replacement for a UFP H-1377.

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

Are you looking at the Blue Ox SwayPro weight distribution shanks, like part #BXW4002? If so, Blue Ox does not give these shanks a specific class rating. All of their shanks fit 2 inch trailer hitches and have a maximum towing capacity of 15,000…

Technically, your A-Frame Bulldog Powered Jack, Item #BD500199, can be powered by the 12 volt circuit on a 7-Way trailer side connector which is in the 1 o'clock position where the wires connect if looking at the back of the 7-Way…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The inner stainless steel ring included with the Spindle Grease Seal Set #BB60005 has an inside diameter of 1.0645 inches (and an outside diameter of 1.375 inches). This ring is designed to install on the spindle for the grease seal to ride on once…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

The distinction you're referring to is about whether or not your Silverado has running boards or steps that sit under the bed and could block the fitment of a frame mounted camper tie-down. The hitch stipulation is in place because…

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the…

Erickson has the spacing for the mounting holes of the #EM09160 before and after the chock at approximately 4-3/8" center to center. Since they unfortunately do not offer a custom backing plate the #e96RR you purchased is going to…

The correct replacement air bags for your Lippert Center Point by Trailair Air-Ride Suspension Upgrade #LC1565391 are the Replacement Air Bag #LC1564251. We also have the Replacement Air Bag Unit #LC293054 and the Replacement Hardware Kit for…

There is indeed a trailer hitch receiver that fits your 2024 Subaru Crosstrek Wilderness, from Curt, with the correct part number being the following: - Curt Trailer Hitch Receiver #C13382 I verified this fit with the manufacturer for you, and it…