Best Jeep Patio Accessories
change vehicle# 1
Camco Hitch-Mounted Flagpole Holder for 2" Hitch Receivers
- view all Patio Accessories
- Flags and Flagpoles
- Camco
More Information >
by: Works Great!06/08/2020
Fits a standard 2” receiver and accepts most brand telescoping flag pulls. I drilled a hole the post so I could lock the flag pole in with a hitch lock.
View More
View Less
by: Stacey06/20/2021
The construction is good (so far). I felt the need to drill new holes for the hitch pin so the mount didn’t stick so far out from the back of my truck. The mounting tube is 2.5” in diameter and my flag pole is only 7/8” in diameter. I had to use pipe insulation on my flag pole to take out the “play” in the pole. Two bolts in the tube to secure the flag would be better than the one supplied and a longer one would be nice as I had to replace the stock one because it was too short. I think I’m happy after the modifications, but haven’t taken the truck for a test run.
View More
View Less
Patio Accessories Questions
- I spoke with Camco and their tech stated the screw-in rod on the ornament is 7/16" so you should be able to fit it through the 1/2" hole on your light topper and screw it into the Telescoping Flagpole w Car-Foot Base, Mount, Bag, and American Flag - Aluminum - 20' Tall Item # CAM51605.
view full answer... - The Telescoping Flagpole w Car-Foot Base, Mount, Bag, and American Flag - Fiberglass - 16' Tall
Item # CAM51606 uses a 2-3/8" outer diameter pole. As a decimal, this would be 2.375 so it would be a little larger than the 2.25 holder.
view full answer... - The Camco Hitch-Mounted Flagpole Holder # CAM51611 is intended for flying a flag while parked. But based on it's construction it should have no problem handling 65 mile per hour wind.
I believe the challenge would be how to secure the flag to the holder while driving. It has a set screw but in order for it to be effective the flag pole would have to be pretty close to 2 inches in diameter.
You would want to make sure the flag and pole you are using are rated for use while...
view full answer... - The pole itself for Sports Fan Telescoping, Fiberglass, Multiple Flag Pole # 94999 is a little less than 1-7/8 inches in diameter so it will fit your Camco base. I have included a link to a video review of the flag pole for you.
view full answer... - I went to the warehouse and took some measurements of the Camco Hitch-Mounted Flagpole Holder, part # CAM51611.
I have attached a photo of the CAM51611 with the dimensions noted. With the distance of 15-1/4 inches from the center of the hitch pin hole to the upright pipe that holds the flag pole I do not think you will have enough space to open the tailgate all the way.
This will hold flag poles up to 2 inches diameter.
view full answer... - The Boone 94999 Telescoping FlagPole is no longer available, but it's replacement is the Camco # CAM51606
telescoping 16 foot flagpole kit. It includes a flag that is 3" by 5" and will hold another of the same size. That said, you could attach a flag up to 6 feet tall on the included connections. It's fiberglass construction means it will look nice for a long time, and it includes a storage bag for easy storage.
view full answer... - The inner diameter of the Camco Hitch Mounted Flagpole Holder part # CAM51611 where the flag installs is 2 inches like you mentioned.
view full answer... - The outer diameter of the Telescoping Flagpole w Car-Foot Base, Mount, Bag, and American Flag # CAM51606 has a collapsed height of 48".
This flagpole also has an outer diameter of 2-3/8", and an extended height of 16'.
view full answer... - The Boone 94999 telescoping flagpole is no longer available. The replacement is the Telescoping Flagpole w Car-Foot Base, Mount, Bag, and American Flag - Fiberglass - 16' Tall # CAM51606. this kit includes a storage bag. It's fiberglass construction means that it will look nice for a long time.
view full answer... - I spoke with my contact at Camco to see if the Hitch-Mounted Flagpole Holder # CAM51611 has a weight capacity or limitations. My contact said that they do not have an advertised weight capacity for # CAM51611, but that the flagpole holder should have no problem holding the 45 pound weight you referenced.
view full answer... - Yes we have three different sizes for you to choose from.
The Taylor Made Waterproof Decorative Ring Buoy - 20" Diameter - White with Blue Bands # 369372.
The Taylor Made Waterproof Decorative Ring Buoy - 25" Diameter - White with Blue Bands # 369373.
And the Taylor Made Waterproof Decorative Ring Buoy - 17" Diameter - White with Blue Bands # 369371.
view full answer... - The Boone Sports Fan Telescoping Pole 94999 is no longer available. Another good choice is the Telescoping Flagpole w Car-Foot Base, Mount, Bag, and American Flag - Fiberglass - 16' Tall # CAM51606. This telescoping 16' flagpole holds up to two flags and has a very durable construction, and includes tire stand and a storage bag. The fiberglass construction should solve your problem caused by condensation/salt spray.
view full answer... - If there was a liquid leaked in the Camco Pop-Up Recycle Container # CAM42983 it would not leak out of the container. If the part # CAM42983 was knocked over on it side though liquid would most likely leak out of the lid.
view full answer... - The snaps will slide on the pole some so the size can vary. It is primarily designed for 2 each of 2 foot x 3 foot or 18 inch x 24 inch flags. But you could put 1 each of a 3 foot x 5 foot on it as long as you were not in 60 mph or more winds. The base, or flat, is 3-3/4 inches x 15-1/2 inches and works great. The manufacturer warranty is 3 years for the base and 1 year for the pole. For the pole you need to be sure not to set heavy items on it like coolers full of your favorite...
view full answer... - Yes, you can hold a patio umbrella in the Camco Hitch-Mounted Flagpole Holder for 2" Hitch Receivers # CAM51611.
You just need to make sure the pole that holes the umbrella is no more than 2 inches in diameter and you'll have a nice shade wherever you go.
view full answer... - The Camco Collapsible Rake, part # CAM42171 has a telescoping handle that allows it to be used at the 29 in retracted length or extended up to 60 inches long.
You just turn the know on the handle and you can adjust the rake to the length you are comfortable with.
view full answer... - Don't worry, I have a solution for you.
The Camco Flagpole Holder # CAM51611 will fit into shanks of 2 inches but what you can do is use an adapter to reduce the opening to 1-1/4 to fit your 2001 Volkswagen Jetta hitch. This adapter # HTAD will be compatible with both a Class I and Class II trailer hitch. It will reduce the amount of weight that can be loaded into the receiver by 50 percent. This means if your tongue weight was 200lbs then you will be reduced to 100lbs,...
view full answer... - Yes, we currently have the Swagman X Mount Bike Carrier Storage Rack # S80940, which can be used to hold your Camco Hitch-Mounted Flagpole Holder for 2" Hitch Receivers # CAM51611 as well as one other ball mount or other trailer hitch receiver accessory. When not in use the receiver tube can be turned to either side for a more compact fit.
view full answer... - The Pop N' Go RV Collapsible Trash Can # VA64ZR does not have a clip or anything to secure the bag to it. That being said, when I put a trash bag in I typically grab any excess of the trash bag and tie a knot with it to tighten the bag up to the rim of the trash can. This could easily be done with the collapsible trash can as well.
view full answer... - I went out to the warehouse and pulled Sports Fan Telescoping, Fiberglass, Multiple Flag Pole # 94999. When you extend the pole it locks into place with friction. The bottom part of each section is wider than the rest of the section so it cannot pull out of the section below it. To retract the sections it does take a fair amount of force so it would not collapse under the weight of a flag (unless the flag was very large).
view full answer...
What our customers are saying:
"Easy place to shop. Fast delivery and great products. Very happy with my purchase."