Thanks so much for the photo, which shows you have a UFP A-60 actuator, which is the same as the Dexter DX7.5L A-60 Brake Actuator - Drum #DX33FR. I can confirm that the correct replacement inner member for both actuators is the Replacement Inner…
Hi Bobby; I have attached a help article below which explains how to replace trailer leaf springs in 5 steps. I also attached an installation video. Between the two you should be able to install the #DX55CR without any issues. Edit: I just double…
Both your axles will use the same Grease Seal #58846. I am going to list all the common replacement parts for each axle so that you have that information. 4,400lb Axle Inner Bearing #L68149 Outer Bearing #LM67048 Inner Race #L68111 Outer Race…
Kenda trailer tires are primarily made in China like most trailer tires. The only Radial trailer tires that I'm aware of that are made in the United States are the Goodyear Endurance line. Carlisle has a bias ply line of tires made in the States,…
Your easiest and best solution would be to go with a new tire in the size of 205/75-14 which fits your 14 inch diameter wheel that is 5.5 inches wide (that's what that number means). This will only take up .2 of an inch more of your available…
According to our FAQ on slipper springs, linked for referenced, the torque specs are as follows: Torque Ratings 1/2 inch Bolts: 45 ft/lbs - 70 ft/lbs 9/16 inch Bolts: 65 ft/lbs - 95 ft/lbs 5/8 inch Bolts: 100 ft/lbs - 120 ft/lbs The Replacement…
I've attached a portion of the instructions for the Dexter Heavy-Duty Suspension Kit for Tandem-Axle Trailers #K71-359-00 that will give your the torque value of 30-50 ft lbs for the hangers, the equalizers, and the shackle straps.
Hey Chris, thanks for reaching out! The Mount-n-Lock SafetyStruts Standard RV Bumper Support Brackets #MO22FR can support up to 400 lbs of cargo and would allow you to use the full 350 lb tongue weight rating of a hitch receiver like the etrailer RV…
Yes, axle spread and wheel base by definition are the same measurements. You will measure from the center of one axle to the center of the 2nd axle to determine what you axle spread is. This may be difficult as some wheels and covers will make this…
For your 34" axle spacing you won't have any issue using just the hardware included with the Dexter Heavy-Duty Suspension Kit #K71-359-00 with your existing equalizers. If you take a look at the install video I attached below, we actually…
Thanks for all that info and we can get you exactly what you are needing. Since you have a 2-3/8" axle that would be a 3,500 lb axle, so you want leaf springs rated for that weight. The concern with springs that exceed the rating of your axle is…
