2016 Nissan Rogue Trailer Hitch
2016 Nissan Rogue Trailer Wiring
2016 Nissan Rogue Brake Controller
2016 Nissan Rogue Towing Mirrors
2016 Nissan Rogue Base Plate for Tow Bar
2016 Nissan Rogue BOLT brand vehicle and hitch locks
2016 Nissan Rogue Roof Rack
2016 Nissan Rogue Trunk Bike Rack
2016 Nissan Rogue Air Filter
2016 Nissan Rogue Suspension Enhancement
2016 Nissan Rogue Transmission Cooler
2016 Nissan Rogue Performance Chip Tuners
2016 Nissan Rogue Vehicle Lights
2016 Nissan Rogue Fluid Filters
2016 Nissan Rogue Salt Spreader
2016 Nissan Rogue Vehicle Engine Heaters
2016 Nissan Rogue Cabin Air Filter
2016 Nissan Rogue Lift Assist
2016 Nissan Rogue Floor Mats
2016 Nissan Rogue Nerf Bars - Running Boards
2016 Nissan Rogue Trim Kits
2016 Nissan Rogue Vehicle Covers
2016 Nissan Rogue Bug Shield
2016 Nissan Rogue Side Window Vents
2016 Nissan Rogue Mud Flaps
2016 Nissan Rogue Vehicle Seat Covers
2016 Nissan Rogue Replacement Mirrors
2016 Nissan Rogue Windshield Wiper Blades
2016 Nissan Rogue Windshield Covers
2016 Nissan Rogue Vehicle Air Mattress
Videos
for Nissan Rogue Owners
Help Articles
Expert Answers
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
I checked to see if there was conversion kit to convert your Malone high bed trailer to a low bed #MPG464-LB. I know this isn't going to be ideal, but what you can do is reuse the U-bolts from the cross bars you have now, and reattach the cross…
The correct replacement idler hub for your Yacht Club Aluminum Clam Shell Snowmobile Trailer is the Trailer Idler Hub Assembly for 2,000-lb Axles part #AKIHUB-545-2-G-2K. These are compatible with 8" wheels.
The Crossbars for Malone MicroSport Trailers - 78" Long - Galvanized - Heavy Duty #MPG4001 are an updated version of the Crossbars for Malone MicroSport Trailers - 78" MPG495. They are 78" and can be used in place of MicroSport…
The Malone MicroSport Trailer #MPG460G uses a #34823 grease seal and #L44643 inner and outer bearings like what you can find in the #BK1-100. For a complete hub assembly with the same 5 on 4-1/2 bolt pattern you can use the #CE13210.
The load bars on the Malone MicroSport Trailer #MPG460G can be adjusted just a bit to create a spread as small as 44 inches. If this pushes the spread into a compatible dimension for your bike rack then you're good to go. If your carrier is still…
What you found is a DOT number and not a speed rating. I was able to figure out which tire you have and it's a Loadstar 4.80-12 that has a 65 mph speed rating. In this size we have a tire that can go 81 mph as part #TT48012C.
The hose on the Empire Faucets RV Handheld Shower Set w/ Slide Bar - 2 Function - Matte Black #EM85PR is 60 inches long. The shower head is 3-1/4 inches in diameter and the handle itself is 5 inches from the base to where it connects to the shower…
The Tekonsha T-One #118304 and Curt T-Connector #C55580 Vehicle Wiring Harnesses are very similar. These are both custom fit wiring harnesses that include a tail light converter, which is required for your 2007 Toyota Sienna because the brake and…
The Pollak Heavy Duty 7-Way part #PK11720 that you referenced is a heavy duty style 7-way. If you check out the attached diagram you'll see how it should be wired.
Since you are needing a replacement lock as well as the key, you can use the Replacement Lock Core and Key #SR03807 for your Sears X-Cargo Sport 20 cargo box.
Yes, you just have to remove the old lights, match the wires and mount the new ones. Please note, that it is usually not a good idea to mix LEDs and incandescent lights, so if you have have side markers or other lights on the trailer, make sure you…
