Today on this 2007 Hyundai Entourage, we're going to install part number 30717. This is the adapter four pole to seven pole vehicle and trailer connector from Tow Ready. Here's our four pole to seven pole adapter, we'll install it on our Hyundai. Our Hyundai already had a seven pole connector on there, but it got damaged pretty bad, so it's already been removed and we just got it down to the bare wires. These are wires from our brake controller and our ground and our reverse light. Here's our four pole wiring harness that was part of our original install. Let's put our new seven pole into place. more
11/4/2014 1:54:11 PM
Today on our 2008 Hyundai Entourage, well be installing the Tow-Ready T1 connector part number 118410.First well need to access the rear cargo area. Then were going to remove the taillight assembly. Weve got three fasteners on each side to remove. As you remove your taillight assembly, be careful not to break the alignment tabs. Next well go ahead and press on the lock of the connector for the rear taillights. Disconnecting these connectors will allow us to plug our new Tow-Ready harness in line with the manufacturers. more
5/22/2012 3:48:25 PM
How to Install: Draw-Tite Max-Frame Trailer Hitch Receiver on your 2008 Hyundai Entourage- Video
Today in this 2008 Honda Entourage, well be installing the draw type hitch part number 75421. This is what our hitch will look like once its installed. Next well go ahead and give you a couple of measurements that will assist you in selecting accessories for your new hitch. From the center of the hitch pinhole to the outer most edge of your bumper is four inches. From the top of receiver tube to the ground is 10-1/2 inches. This will assist you with selecting accessories such a draw bar, a bike rack or a cargo carrier. more
5/21/2012 2:07:06 PM
Trailer Hitch Installation - 2008 Hyundai Entourage - Hidden Hitch- Video
Today on our 2008 Hyundai Entourage, we'll be installing the Hidden Hitch, part number 70761. This is what our hitch will look like once it's installed. Next, we'll go ahead and give you a couple of measurements that will assist you in selecting accessories for your new hitch. From the center of the hitch pin hole to the outermost edge of the bumper is 4 inches. From the top of the receiver tube to the ground is 10-1/2 inches. This will assist you in selecting accessories such as the drawbar, a bike rack, or a cargo carrier. more
5/21/2012 2:06:33 PM
Filter Videos
Filter Videos
