A Closer Look at the Sylvania H11SL LED Fog and Powersports Bulb Video

Hi Ross; the #SP-179275 and #e69SR are identical. The only real difference between the two slipper springs is going to be the cost. Since there will be no difference in performance in salt water I would say get whichever one is cheaper.

I'd be more than happy to help you out! If you can measure the hub-face and spring-center measurements of your current axle that will help me know what you're needing. For example, the etrailer Trailer Axle with Idler Hubs #e65GR has a…

Thanks for the photo! Using the VIN I was able to gather the necessary information needed to help you find the correct idler hubs. For this, I recommend the CE Smith Trailer Hub Assembly part #CE13311. This hub uses a L44649 inner/outer bearing,…

Thanks for the info! Based on that you need the Bearing Kit #BK1-100 which is for the common BT8 spindle like what it sounds like you have. This kit comes with 2 of the L44643 bearings, the matching races, a cotter pin, and a double lip grease seal…

I may have a solution that will save you some money and work. I spoke with our tire expert and his suggestion was to lower the tire pressure a little until you are comfortable with the way the trailer handles and rides. We always recommend using the…

Carry-On steel-mesh trailer model 5x10GW2K uses a 2000-lb-rated idler axle. We have several 72-inch 2K-rated idler axle kits that come complete with hubs, bearings, races, seals, etc. We do not offer 2K axles without hubs. All of these use a leaf…

The Dexter Trailer Axle w/ Idler Hubs #20545I-EZ-72-15 is designed to fit 2,000 lb trailer axles. If that's what you have then this will fit and the U-bolt kit part #APUBR-10 that you referenced would also work since that's what it's…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…