DeeZee Truck Toolbox - Wheel Well Toolbox - DZ95B Review

content loading

Customers compare DZ95B to these similar products




Products Featured in this Video



Review of DeeZee Toolbox DZ95B


Today we're going to review part number DX95B. This is the DeeZee Speciality Series driver's side wheel well toolbox. This toolbox has a rust-proof Brite-Tread aluminum construction. It is a wheel well style for the driver's side. This would fit on top of the wheel well, and this would be behind the wheel well. This will help maximize storage space, keeping most of your truck bed free for any larger cargo you need to carry.

It does have a locking lid here at the top, which will provide security for anything you put inside the toolbox. The lock is right here on the top. Basically if you close it, it does come with the two keys. Just turn it a quarter of a turn. That would lock it into place so nobody could get into it.

When you remove the key, it does have a nice hinged lock cover that would just fold down over the lock to keep any dirt or grime from getting inside the lock. To open it, just put the key in, turn it a quarter of a turn. That would open it up. This will give you secure, weather-resistant storage for your pickup truck bed. The lid itself has a piano hinge that runs the full length of the lid.

This will give you a lot better stability for the lid, and help minimize wear. It also has the foam gasket around the whole top of the lid, so that when you close it, it will keep any dirt or grime from getting inside the toolbox. It does have a one-piece front/back/bottom. And these welded ends provide maximum strength and durability. It does use a very simple installation and includes these two mounting brackets that are included to mount it to your truck bed, foam tape to help seal it and prevent it from scratching your truck bed.

All the mounting nuts, bolts, and hardware. And it also gives you an actual additional hinged panel right here and two angle support brackets. And what that would do is, on the inside, on this deep section here, if you wanted to make another separate compartment, that can be installed on the inside to give you another separate compartment with a panel, or door on it also. This will sit on the truck bed floor inside the side rails. It does fit under most tonneau covers. It does have a nice black powder-coat finish, and it is made in the USA. Now the interior capacity on this toolbox is 2.2 cubic feet. It does come with a limited lifetime warranty. And a few overall dimensions on this. The length on this box is 37" long. The width is 7-3/4". And the height at the very back here is 19-1/2". So with this on the driver's side behind the wheel well, the lid will open to the inside of the truck bed. And then again just to lock it, turn the key a quarter of a turn, and that would lock it into place. That should do it for the review on part number DZ95B, the DeeZee Speciality Series driver's side wheel well toolbox.


Questions and Comments about this Video

John

Can you install or ship a additional lock or increase locking capabilities ?

Etrailer Expert
Reply from Patrick B.

Adding aditional locks is certainly do-able, we do not have any direct or custom fit solutions. Adding a hasp or two with padlocks may not be the prettiest solution, but very common on older boxes or where replacement locks cannot be found. Check out part # 722DPF .

Info for this part was:

Employee Lindsey S
Written by:
Lindsey S
Employee Leah B
Edited By:
Leah B

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.