bing tracking image

Curt Ball Mounts - Fixed Ball Mount - C45510 Review

content loading

Customers compare C45510 to these similar products

Products Featured in this Video

Review of Curt Ball Mounts C45510

Today, well be reviewing Part Number C45510. This is a Curt Class II Drawbar rated 00:00:04 at 3,500 pounds. Its made from a study, steel construction. It's going to be corrosive-resistant with a black gloss powder coat finish. It goes through a high-quality manufacturing process, so it's going to be good for strong, consistent cuts and welds, as well as a nice, clean, smooth surface. When using this drawbar, it can only be used in the rise position. It is designed for 1-1/4" by 1-1/4" trailer hitch receivers.

It is going to be Class I or Class II compatible. It's going to give us a gross towing weight of 3,500 pounds at the maximum tongue weight of 350 pounds. Depending on your hitch, you may be limited to your hitch's rating 00:00:40. When choosing the hitch ball, you want to make sure that it does not exceed the ball hole diameter, which, for this particular ball mount, is going to be 3/4 inch. This will use a hitch ball with 3/4 inch shank diameter. The distance from the center of the hitch pin hole to the center of the ball hole is going to give us a measurement of about 9-1/2 inches. It's going to give us a 3-1/8 inches rise, and that's measuring from the inside top inaudible 00:01:18 the receiver tube to the top of the ball platform.

Now, we got a curve right here, so if we measure from that curve to the center of the hitch pin hole, it's going to give us a measurement of 3-1/2 inches, and then the distance from the center of the hitch pin hole to the back of the shank is going to measure 1-1/2 inches. You can see here that the shank is a nice, solid piece. The drawbar width, here at the widest point, is going to be 2 inches here at the ball platform. This portion here slides into the hitch of your vehicle. You got to put in there until you get the pin holes to line up, and then you can install a hitch pin and clip or a hitch pin and lock. These are sold separately. You can go to our website and type in Part Number PC2, and it will refer you to this half inch pin that comes with a clip, or you can look at the product's product page under related items to view some other options.

That's going to complete today's review of Part Number C45510. This is a Curt Class II Drawbar. .

Questions and Comments about this Video

Info for this part was:

Employee Lindsey S
Written by:
Lindsey S
Employee Leah B
Edited By:
Leah B

At we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.