Ultimate Overview of the BulletProof Hitches Weight Distribution Shank for 2" Hitches Video

The Draw-Tite QSP Trailer Hitch Silencer and Cover for 2" Hitch Receivers #63080 is the closest thing we have found to what you are seeking. This plastic part does serve as an anti-rattle and will reduce that wear from the softer metal. There…

You can use a weight distribution shank from another manufacturer with your Blue Ox Sway Pro system if necessary to provide the correct coupling height and sufficient ground clearance. Based on your measurements it appears you actually need about…

Thanks for reaching out! The biggest difference between hitch receiver height and trailer coupler height is 1", so for your application I do recommend using the 9-hole shank #BXW4002 so you can get to that level setup. Keeping the trailer level…

Brent, to remove the Replacement Spring-Bar Release Clip for Fastway e2 Weight Distribution Systems with Round Bars #FA94-02-1059 you are going to need to start by getting the lower screw out of the clip which you're going to need to pry out…

As far as I know this is not a common problem, and not something that we have had reported as an issue for the #FA94-00-1000. It is important to make sure that everything is secure when installing the weight distribution hitch. The spring bars should…

To remove the retaining clips #17109 on a Curt weight distribution system with round bars you would first remove the bottom screws holding them on. Then you would push the clips up so the wider part of the hole can slip off the top pin. The top pin…