What folds flat like a pancake for easy storage, unfolds in seconds, and comes with a carry bag for easy transport? The Flap Jack! These durable jack blocks provides a stable base for your trailer, RV, or camper, making setup quick and hassle-free.Highlights Folds Flat Like a Pancake: Each block collapses down small to maximize storage space and make transport easy. Engineered for Stability: Block locks firmly into place when unfolded, giving you a stable base every time.
This cartridge heater clips into the cavity of your engine block and transfers heat through the block to help warm engine fluids resulting in easier start-ups, faster heating of your cab, and less wear and tear on your vehicle in cold weather.Features: Ensures smoother start-ups and faster heating and defrosting of your cab Clips into cavity of engine block - no need to remove your frost plug or drain your coolant Dielectric grease can be applied to heater before being installed in the engine block Warms engine fluid to increase lubrication and performance Keeps fluid from thickening and protects against damage in cold weather Pre-heats engine to reduce condensation in the engine block Emits less pollution and fewer gas emissions Includes removable power cord Route through your grille and plug into standard 120-volt AC outlet Durable cast-aluminum heating element Custom fit for your vehicle CSA approved Made in the USA Specs: Cord length: 5' Wattage: 400 watts Amperage: 3.3 amps 1-Year limited warranty Notes: Do not use this heater with a 100-percent antifreeze solution.
What folds flat like a pancake for easy storage, unfolds in seconds, and comes with a carry bag for easy transport? The Flap Jack! These durable jack blocks provides a stable base for your trailer, RV, or camper, making setup quick and hassle-free.Highlights Folds Flat Like a Pancake: Each block collapses down small to maximize storage space and make transport easy. Engineered for Stability: Block locks firmly into place when unfolded, giving you a stable base every time.
This winch includes a 50' cable that increases the load capacity with double-line-pulling capability. Winch works anywhere AC power is available and includes a Load/Unload remote and a spring-loaded clutch for releasing cargo without power.Features: Built-in, hand-held remote with 10' cord Dual controls for Load/Unload and Run/Off functions Dynamic motor brake and mechanical friction brake Dynamic brake helps bring load to immediate halt without coasting Mechanical brake locks reel to hold load Spring-loaded clutch lever for releasing load without power Provides smooth load control from locked or freewheel position Automatically returns to locked position when released Freewheel option allows cable to be removed by hand 120-Volt, AC operation 10', 3-Wire grounded power cord Flexible, high-strength, 7 strand x 19 gauge, galvanized aircraft cable Pulley block and snap hook included for double-line pulling 50' of Cable - great for double-line operation Safety snap hook keeps load securely attached Wire cable can be swapped out for 2" wide strap Emergency crank handle comes standard Use in the event of power failure Heat-treated gears provide smoother, quieter ride and greater strength Precision needle bearings in high-load areas Create low friction and promote longer life Die-formed base is adapted for quick-mounting applications High-impact, weather-resistant case Provides excellent protection for internal components Safer than open-reel models Brushed stainless steel front plate for superior rust resistance Made in the USA Specs: Load capacity: 2,700 lbs Double-line capacity: 4,000 lbs Rating based on 10' pull Current draw: 6 amps at 120 volts Electric winches should be used intermittently - maximum continuous run time is 4 minutes Gear ratio: 570:1 Cable dimensions: 7/32" diameter x 50' long Load speed (feet per minute): No Load/Full Reel - 9 Full Load/Full Reel - 4 1-Year limited warranty Determining Your Load Capacity A common ratio for determining your winch load capacity is 2:1.
What folds flat like a pancake for easy storage, unfolds in seconds, and comes with a carry bag for easy transport? The Flap Jack! This durable jack block provides a stable base for your trailer, RV, or camper, making setup quick and hassle-free.Portable & Adventure-Ready Designed with campers and travelers in mind, the Flap Jack block is lightweight, compact, and comes with a zippered carry bag that keeps all 3 pieces together for easy transport and storage. Whether you're hitting the road or setting up at the campsite, this jack block is a must-have for a hassle-free setup.
When temps drop, you don't want to deal with your truck or diesel equipment fighting you. This custom-fit block heater warms coolant so oil and diesel stay fluid and your engine is ready to start and get to work in the cold.Features to know about No More Cold-Weather Struggles Last winter, cold mornings meant slow cranks and long warm-ups. This block heater keeps coolant warm so your engine starts quick and avoids the wear that cuts engine life. At 1,250 watts/120 volts, it delivers steady heat for reliable starts and faster warm-ups without the long idle.
This frost-plug heater replaces the frost plug in your engine block and submerges in the coolant to keep engine fluids from thickening. Results in easier start-ups, faster heating of your cab, and less wear and tear on your vehicle in cold weather.And because starting your engine when it's warm creates less condensation in the engine block than starting it when it's cold, your engine will get better initial fuel vaporization, which causes fewer emissions and less pollution.
This kit makes it easy to carry a canoe on most roof rack crossbars and naked roofs. Foam blocks provide a safe surface between your vehicle and boat. Included straps and tie-downs ensure that your canoe stays in place during transport.Features: Complete kit includes everything you need to transport 1 canoe on the roof of your vehicle 4 Durable, closed-cell foam blocks with gunwale cutouts hold the canoe steady Non-skid underside keeps blocks in place during loading and protects your roof 2 Cam buckle load straps secure to crossbars or run through the vehicle's interior to secure canoe and blocks to the roof 2 Bow/stern tie-downs anchor canoe to your vehicle Quick and easy installation on vehicles with a naked roof and most crossbar styles Made in the USA Specs: Application: naked roofs and round, square, aero, elliptical, and most factory crossbars Carrying capacity: 1 canoe Weight capacity: 110 lbs Foam block dimensions: 6" long x 4-5/8" wide x 4" tall Load strap length: 15' long Bow/stern strap length: 12' Weight: 2.2 lbs 1-Year warranty
Interlocking blocks stack to different heights and can be positioned beneath jacks, stabilizers or RV wheels to add just enough lift to level your rig.Features: Stackable blocks provide extra lift to level your trailer or motor home Position beneath jacks, stabilizers or trailer wheels Interlocking design guarantees no shifting or collapsing once stacked Stack straight up for extra height Stagger blocks to create a ramp so you can easily drive up Durable plastic construction Storage case with integrated carrying handle included Specs: Quantity: 4 blocks Individual block dimensions: 8-1/4" wide x 8-1/4" long Weight capacity: 30,000 lbs Lifetime warranty Note: The manufacturer does not recommend stacking more than 5 blocks high
This frost-plug heater replaces the frost plug in your engine block and submerges in the coolant to keep engine fluids from thickening. Results in easier start-ups, faster heating of your cab, and less wear and tear on your vehicle in cold weather.And because starting your engine when it's warm creates less condensation in the engine block than starting it when it's cold, your engine will get better initial fuel vaporization, which causes fewer emissions and less pollution.
Replaces 2 foam blocks for your Malone Canoe Carrier with Tie-Downs (MPG156). Non-skid underside keeps blocks in place and protects your roof. Closed-cell foam is durable and holds your boat steady.Features: Replaces 2 foam blocks for your Malone Canoe Carrier with Tie-Downs (MPG156). 4 Blocks are suggested to safely transport a kayak, canoe, or SUP Closed-cell foam blocks are durable and hold your canoe steady Non-skid underside keeps block in place and protects your roof Made in the USA Specs: Application: round, square, aero, elliptical, and most factory crossbars Overall dimensions: 6" long x 4-3/4" wide Fits: Part number MPG156 , Malone Canoe Carrier with Tie-Downs
This frost-plug heater replaces the frost plug in your engine block and submerges in the coolant to keep engine fluids from thickening. Results in easier start-ups, faster heating of your cab, and less wear and tear on your vehicle in cold weather.And because starting your engine when it's warm creates less condensation in the engine block than starting it when it's cold, your engine will get better initial fuel vaporization, which causes fewer emissions and less pollution.
... Supports trailer jacks and stabilizers or can be used as leveling blocks for even the largest RVs.Features: Universal jack pads use both rubber and plastic for stability and toughness Position beneath jacks, stabilizers or trailer wheels Individual layers can be separated for a variety of configurations Remove rubber pieces to allow cores to interlock with each other Stack them in a column or as a pyramid for RV leveling Grab handle built in Specs: Quantity: 1 block Individual block dimensions: 12" long x 12" wide x 2" high 1-3/4" tall without top rubber installed Extra cores add 1-1/2" height when stacked Weight: 7.6 lbs Weight capacity: 40,000 lbs 2-Year limited warranty Note: When in use, place the handle to the side, not where the tire will be driving on or off.
... Supports trailer jacks and stabilizers or can be used as leveling blocks for even the largest RVs.Features: Universal jack pads use both rubber and plastic for stability and toughness Position beneath jacks, stabilizers or trailer wheels Individual layers can be separated for a variety of configurations Remove rubber pieces to allow cores to interlock with each other Stack them in a column or as a pyramid for RV leveling Grab handle built in Specs: Quantity: 1 block Individual block dimensions: 12" long x 12" wide x 2" high 1-3/4" tall without top rubber installed Extra cores add 1-1/2" height when stacked Weight: 7.6 lbs Weight capacity: 40,000 lbs 2-Year limited warranty Note: When in use, place the handle to the side, not where the tire will be driving on or off.
... Supports trailer jacks and stabilizers or can be used as leveling blocks for even the largest RVs.Features: Universal jack pads use both rubber and plastic for stability and toughness Position beneath jacks, stabilizers or trailer wheels Individual layers can be separated for a variety of configurations Remove rubber pieces to allow cores to interlock with each other Stack them in a column or as a pyramid for RV leveling Grab handle built in Specs: Quantity: 1 block Individual block dimensions: 12" long x 12" wide x 2" high 1-3/4" tall without top rubber installed Extra cores add 1-1/2" height when stacked Weight: 7.6 lbs Weight capacity: 40,000 lbs 2-Year limited warranty Note: When in use, place the handle to the side, not where the tire will be driving on or off.
Interlocking blocks stack to different heights and can be positioned beneath jacks, stabilizers, or RV wheels to add enough lift to level your rig. Durable polyethylene construction.Features: Stackable blocks provide extra lift to level your trailer or motor home Position beneath jacks, stabilizers, or trailer wheels Interlocking design guarantees no shifting or collapsing once stacked Stack straight up for extra height Stagger blocks to create a ramp so you can easily drive up Durable polyethylene construction Included strap secures blocks together for easy, compact storage Specs: Quantity: 4 Block dimensions: 8-1/8" long x 8-1/8" wide x 1-3/8" tall Including handle: 10" long 1-Year warranty Stackers Blocks and Chock Stackers leveling blocks can be stacked directly on top of each other for supporting a trailer tongue, or you can stagger the blocks to create a ramp.
This trailer jack block makes leveling and stabilizing your RV or trailer simple. No more wrestling with wobbly jacks or stacking sketchy wood blocks. It's lightweight, sturdy, and takes the hassle out of setting up your campsite.Features: Magnets That Stick: Integrated magnets allow the block to instantly attach to your jack, so no fumbling around trying to keep it in place Stackable for More Height: For additional height, you can stack 2 blocks together Recessed Post Hole: Each block features a 2-1/2" recessed post hole, making it compatible with jacks both with and without footplates.
This cartridge heater clips into the cavity of your engine block and submerges in the coolant to keep engine fluids from thickening. Results in easier start-ups, faster heating of your cab, and less wear and tear on your vehicle in cold weather.And because starting your engine when it's warm creates less condensation in the engine block than starting it when it's cold, your engine will get better initial fuel vaporization, which causes fewer emissions and less pollution.
This cartridge heater clips into the cavity of your engine block and submerges in the coolant to keep engine fluids from thickening. Results in easier start-ups, faster heating of your cab, and less wear and tear on your vehicle in cold weather.And because starting your engine when it's warm creates less condensation in the engine block than starting it when it's cold, your engine will get better initial fuel vaporization, which causes fewer emissions and less pollution.
This cartridge heater clips into the cavity of your engine block and produces heat keep engine fluids from thickening. Results in easier start-ups, faster heating of your cab, and less wear and tear on your vehicle in cold weather.And because starting your engine when it's warm creates less condensation in the engine block than starting it when it's cold, your engine will get better initial fuel vaporization, which causes fewer emissions and less pollution.
When temps drop, you don't want to deal with your equipment fighting you. This custom-fit block heater warms coolant so oil and diesel stay fluid and your John Deere engine is ready to start and get to work in the cold.If you don't know your engine number you can find it on the metal data plate or sticker located on the side of the engine block, often near the valve cover. The engine serial number (ESN) is 13 or 17 characters long. The first two letters let you know what factory produced it.
Adds 8" of height to reduce jack strain. Each block holds 6,000 lbs and has a magnetic base that sticks to your jack pad. Stackable, nestable, and stable, this 6-pack is built for full trailer support.It's a great option for tandem axles or multi-point setups where more blocks mean less stress. Specs Dimensions and Weight: Block height: 8" tall Block weight: 5.3 lbs per block Capacity: Weight rating (per block): 6,000 lbs per block
Kick the crud off your boots and level out your trailer! This kit pairs a Flap Jack stabilizing block with a shoe scraper, both packed neatly in one carry case. It's the clean, compact combo your campsite (and floors) will thank you for.Highlights Folds Flat Like a Pancake: Jack block collapses down small to save space and simplify transport. Cleans Fast: Grid-style scraper knocks off dirt, mud, and debris in seconds.
Interlocking blocks stack to different heights and can be positioned beneath jacks, stabilizers or RV wheels to add just enough lift to level your rig.Features: Stackable blocks provide extra lift to level your trailer or motor home Position beneath jacks, stabilizers or trailer wheels Interlocking design guarantees no shifting or collapsing once stacked Stack straight up for extra height Stagger blocks to create a ramp so you can easily drive up Durable plastic construction Storage case with integrated carrying handle included Specs: Quantity: 8 blocks Individual block dimensions: 8-1/4" wide x 8-1/4" long Weight capacity: 30,000 lbs Lifetime warranty Note: The manufacturer does not recommend stacking more than 5 blocks high
Filters
